User manual WHIRLPOOL AKM 359/NE PROGRAM CHART

[. . . ] • Do not use the hob as a support or worktop. • Do not leave the hot plates/cookers turned on when they are empty. • Do not rest plastic, aluminium foil, cloths, paper etc. • The hob is fitted with hot plates/cookers of different sizes. [. . . ] • The hob should be treated periodically with specific products available from the shops, following the manufacturer's instructions. Telescopic knobs (depending on model) TROUBLESHOOTING GUIDE The hob does not work: • The knobs can be lifted approx. • After cleaning, restore the knob to its original position. The hob will not switch off: - Make sure that the power supply is on. - Turn the hob off and on again, to make sure that the problem has been solved. - Make sure that the knob is not turned to “0”. Turn the multi-pole switch to “Off” for a few minutes and then turn it back to “On”. - disconnect the hob immediately from the power supply. To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation. AFTER SALES SERVICE Before you call the After Sales Service • Make sure that you cannot solve the problem yourself following the points described in chapter “Troubleshooting Guide“. If after the above checks the fault still occurs, get in touch with the nearest After Sales Service. Please give: • a short description of the fault; • the exact type and model of hob; • service number (i. e. , the number that follows the word SERVICE on the rating plate under the hob itself). The service number is also indicated on the guarantee booklet; • your full address; • your telephone number. If any repairs are required, please contact an authorised After Sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). Failure to comply with these instructions may compromise the safety and quality of the product. Declaration of conformity • This cooktop is suitable for contact with foodstuffs and complies with EEC (CE) Regulation n. • This hob (Class Y) has been designed to be used only for cooking. Any other use (such as heating a room) is improper and dangerous. • This hob has been designed, constructed and marketed in compliance with: - safety objectives of the “Low Voltage” Directive 2006/95/CE (which replaces 73/23/CEE and subsequent amendments); - protection requirements of EEC Directive “EMC” 89/336; - requirements of EEC Directive 93/68. The Manufacturer reserves the right to change product specifications without prior notice. INSTALLATION Recommendations Important: Disconnect the hob from the mains before carrying out any installation work or servicing. • All electrical connections must be made before connecting the appliance to the power supply. • Installation must be carried out by a qualified technician in accordance with the manufacturer's instructions and in compliance with local regulations. • Unpack the hob and make sure that the appliance has not been damaged during transport. If you are not sure contact the dealer or the nearest service centre. • If the worktop is made of wood, use the spring clips and screws provided. 1) as shown, paying attention to the specified distances. [. . . ] 70 mm of the cable sheath from the power supply cable (G). Insert the cable (G) through the opening in the lid (F). Important: remove any protective film before installing • Insert the cable into the cable clamp and connect the the hob. conductors to the terminal block as indicated in the Make sure that that the opening in the worktop for the hob is diagram printed on the lid. [. . . ]