User manual WHIRLPOOL AKM 394/JA INSTRUCTION FOR USE

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual WHIRLPOOL AKM 394/JA. We hope that this WHIRLPOOL AKM 394/JA user guide will be useful to you.

Lastmanuals help download the user guide WHIRLPOOL AKM 394/JA.


Mode d'emploi WHIRLPOOL AKM 394/JA
Download

You may also download the following manuals related to this product:

   WHIRLPOOL AKM 394/JA PROGRAM CHART (443 ko)

Manual abstract: user guide WHIRLPOOL AKM 394/JAINSTRUCTION FOR USE

Detailed instructions for use are in the User's Guide.

[. . . ] When replacing the grids, make sure that the panstand area is aligned with the burner and that the burner feet are fitted in the respective housings on the hob surface. In the case of single grids, make sure that they fit on the burner cap protuberance. Models equipped with electrical ignition plugs and safety device require thorough cleaning of the plug end in order to ensure correct operation. Check these items frequently, and if necessary, clean them with a damp cloth. [. . . ] If the appliance is arranged for a type of gas different from that available, refer to the paragraph “Adjustment to different types of gas”. Manufacturer: Whirlpool Europe S. r. l. Borghi, 27 21025 Comerio (VA) ITALY 5019 619 01387 NOTES: • • Improper use of the grids can result in damage to the hob surface. Do not position the grids upside down or drag them across the hob. If the hob has a glass ceramic top, do not use: - Cast iron griddles or terracotta pots and pans - Heat diffusers (e. g. metallic mesh) - Two cookers for the same pot In case of prolonged use, additional ventilation may be needed (opening a window or increasing the extraction force of the hood). This appliance is not intended for use by people (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety. Keep children away from the hob when it is in use and do not let them play with the controls or any other appliance parts. Warning: the glass lid (if provided) may shatter if overheated. Before closing it, be sure that all the burners are off. After use, make sure that the knobs are in position OFF and close the main gas delivery or cylinder tap TROUBLESHOOTING GUIDE If the hob will not operate correctly. Before calling the After-Sales Service, refer to the Troubleshooting Guide to determine the problem. 1. • • • • • • • • 2. The burner fails to ignite or the flame is not even Check that: The gas or electrical supplies are not shut off and especially that the gas supply tap is open. If the appliance is installed in a cellar or basement, it is advisable to provide an air vent of 65 cm, irrespective of the room volume. The law requires that all gas appliances are installed by competent persons in accordance with the current gas safety regulations. Failure to install appliances correctly may lead to prosecution. It is in your own interest, and that of safety, to ensure that the law is complied with. The hob should be installed in accordance with the Gas Safety (Installation and Use) Regulations, the Building Regulations issued by the Department of the Environment and the Building Standard (Scotland) (Consolidation) Regulations, issued by the Scottish Development Department. In the G. B. , CORGI registered installers work to safe standards of practice. Gas Safety Regulations INSTALLATION TECHNICAL INFORMATION FOR THE INSTALLER • • This product can be embedded in a worktop 20 to 40 mm thick. If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening in the work surface. This panel must be positioned at a maximum distance of 150 mm below the upper surface of the work surface but, in no case less than 20 mm from the bottom of the hob. In the case that you intend to install an oven beneath the hob, make sure that it is manufactured by Whirlpool and equipped with a cooling system. The manufacturer declines all liability if another brand oven is installed beneath the hob. Before installation, make sure that: the local gas delivery conditions (nature and pressure) are compatible with the settings of the hob (see the rating plate and injector table). [. . . ] Slacken the screws (A) off and position the cooktop in See the oven instructions booklet. such a way that the taps are aligned with the oven knobs. Connect tongues (A) to end (B) as shown in the figure. Adjust the height of the tap bracket (C) according to the 2. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL AKM 394/JA

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL AKM 394/JA will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag