User manual WHIRLPOOL AKM 400 NB PROGRAM CHART

[. . . ] Removable panstand grids Medium burners Large burner Small burner Triple crown burner Small burner control knob Large burner control knob Triple crown burner control knob Medium burner control knob Medium burner control knob Symbols Shaded circle Large flame and star Small flame Tap closed Maximum opening/delivery and electric ignition Minimum opening or reduced delivery Operation of burners with safety device and electric ignition To light one of the burners: • Press the relative knob and turn it anticlockwise to the large flame and star setting . — The separator panel, positioned beneath the cooktop at a minimum distance of 20 mm, must be sealed. • At the same time, hold the knob down until the burner ignites. [. . . ] If the burner does not ignite, repeat the operations described above. Note: — Should particular local conditions of the delivered gas make ignition of the burner difficult, it is advisable to repeat the operation with the knob turned to the small flame setting . — The burner safety device shuts off the gas supply to the burner if the flame goes out accidentally (because of a sudden draught, an interruption in the gas delivery, boiling over of liquids, etc. ). Using the triple crown burner The innovative feature of this burner is that two burner caps can be controlled separately with the same knob. If the distance “A” between the wall cabinets is greater than the width of the cooktop, the height “B” must be a minimum of 400 mm. Before installing a hood above the cooktop please refer to the hood instructions, which specify the correct distance. INJECTORS TABLE Type of gas used Type of burner Injector marking CATEGORY II2H3+ Reduced Gas pressure Rated heat Rated heat capacity consumption capacity min. [. . . ] INJECTORS TABLE Type of gas used Type of burner Injector marking CATEGORY II2H3+ Reduced Gas pressure Rated heat Rated heat capacity consumption capacity min. [. . . ]