User manual WHIRLPOOL AKM 608/01 AV PROGRAM CHART

[. . . ] When the burner is lit, keep the knob pressed for about 5 seconds to allow the thermocouple (provided for each burner) to heat up. This safety device shuts off the gas if the flame goes out accidentally (draughts, interruption of gas, liquids boiling over, etc. ). The device must not be operated for more than 15 sec. If the burner does not remain lit after this time, wait at least one minute before trying to light it again. [. . . ] • This hob (Class 3) is designed only for domestic use for cooking food. Caution • Keep children away from the hob when in use and do not let them play with the knobs or any other part of the appliance. • The protective rubber feet under the grids represent a choking hazard for young children if swallowed. • After removing the grids, make sure all the rubbers are correctly fitted. • After using the hob, always make sure the control knobs are turned off and close the main cock of the gas supply pipe or cylinder. 22 INSTALLATION (FLUSH OR SEMI-FLUSH) Technical information for the installer Important: Given the weight of the product, two people are needed during installation. • This product can be fitted in a 20 to 50 mm thick worktop. • If an oven is not provided for under the hob, insert a separating panel of size at least equal to the opening in the worktop. This panel must be positioned not more than 150 mm from the upper surface of the worktop, and never less than 50 mm from the bottom of the hob. • To install an oven under the hob, make sure it is manufactured by Whirlpool and equipped with a cooling device. The manufacturer declines any liability if another brand of oven is installed. Before installation, make sure: • The local gas supply (type and pressure) and hob settings are compatible (see the dataplate and injector table). 3 27 8 -+1 0 25 FIXING TO THE SUPPORT STRUCTURE FLUSH-MOUNTING MODEL Important: The following operation must be carried out by a competent technician. Installation can be carried out on different materials such as masonry, metal, solid wood and plastic laminated wood provided it is heat resistant (T 90°C). Make an opening in the cabinet top, of the dimensions shown in fig. 1; to correctly install the hob a 2 mm deep milling must also be made in the top (Fig. 4). 1160 32 80 1161+1 1148 0 27 32 8 1 +1 0 0 6, 5 2 R. 4 Note: In case of laminated tops less than 2 mm thick, carry out the milling in the cabinet as shown in the diagram (detail). Before positioning the hob, apply the adhesive sealing strip (supplied) on the entire bottom surface that will be in contact with the top (fig. Carry out these operations: • Place the hob on the milling and, using the screws and brackets supplied, fix it to the support structure, ensuring that it is perfectly flat (fig. • Carefully trim the excess sealing strip (fig. In case of installation on wood (especially chipboard), if there are small spaces between the milling and the edge of the hob, fill with minimum amounts of silicone. The bottom part of the casing must be entirely accessible after installation. [. . . ] • Adjust the cock minimum settings. Note: With liquefied petroleum gas (G30/G31), the minimum adjustment screw (by-pass) must be fully screwed down. This does not affect hob operation or its performance. CARE AND CLEANING OF HOB COMPONENTS The grids, burner caps and burners can be removed to facilitate cleaning. Wash them by hand with hot water and neutral detergent, making sure to remove any encrustations and checking that the burner openings are not clogged. [. . . ]