User manual WHIRLPOOL AKM 613/NB INSTRUCTION FOR USE

[. . . ] Position the 4 brackets (F) as shown in the figure, in accordance with the thickness of the worktop. Fix the 4 screws (G) in holes (H). . • 46 ELECTRICAL CONNECTION • Make sure the appliance is installed and connected to the electricity supply by a qualified technician in accordance with the manufacturer’s instructions and in compliance with local regulations. The installer is responsible for the correct electrical connection of the appliance and the observance of the relative safety prescriptions. The appliance must be connected to the electricity supply by means of an all-pole disconnect switch with minimum contact gap of 3 mm. [. . . ] with little water in order to cut down cooking time. A pressure cooker allows you to save even more energy and time. . • • • • NO! OK! PROTECTING THE ENVIRONMENT 1. Packing • The packaging material can be100% recycled, as confirmed by the recycling symbol ( ). Products • The appliances are built from recyclable materials. If you decide to scrap the appliances act responsibly and observe local waste disposal by laws. Cut off the power cords so that the appliances cannot be connected to the mains. The appliances are designed, built and sold in compliance with: • The safety requirements of “Low Voltage” Directive 73/23/EEC. • The protection requirements of EMC Directive 89/336/EEC. • The requirement of Directive 93/68/EEC. • This appliance complies with Class “Y” fire protection category. Declaration of conformity CE • These appliances are designed to come into contact with foodstuffs and they are constructed in compliance with Directive 89/109/EEC. The appliances are designed solely for use as cooking appliances. for room heating) is considered as improper use and potentially dangerous. • . PRECAUTIONS AND GENERAL RECOMMENDATIONS • • • • • • Before any maintenance on the appliance disconnect it from the electrical power supply. Keep children away from the appliances when they are in use. The appliances must be repaired or adjusted exclusively by a qualified technician. Make sure that the electrical wires of other electrical appliances near the cooktop do not come into contact with hot parts. Do not switch on the hotplates/cooking zones when there is no pan in position. The cooktop features different size hotplates/ cooking zones. Use pans whose base diameter is the same as or slightly larger than the diameter of the hotplate/cooking zone. The use of pans with concave or convex bottoms may damage the cooktop. Do not use the cooktop as a work surface or • • a support surface. [. . . ] • Do not use abrasive products, bleach, ovencleaner spray or pan scourers. • The cooktop should be treated periodically with a proprietary brand of protective wax for glass-ceramic hobs. . TROUBLESHOOTING GUIDE Cooktop not working • Ensure that the cooktop is receiving electrical power. • Control knob set to “0” ?Set the main disconnect switch upline of the appliance to “OFF” for a few minutes and then back to “ON” and see if the problem persists. 49 AFTER SALES SERVICE Before contacting After Sales Service 1. [. . . ]