User manual WHIRLPOOL AKM274/IX PROGRAM CHART

[. . . ] • Caution: the lid (where present) might break if overheated. Before closing it, make sure that all the burners are off. • Warning: The protective rubber feet on the panstand grids represent a choking hazard for young children. After cleaning the panstand grids, please ensure that all the rubber feet are correctly fitted. Declaration of conformity • This cooktop has been designed, constructed and marketed in compliance with: - safety requirements of EEC Directive “Gas” 90/396; - safety requirements of EEC Directive “Low voltage” 73/23; - protection requirements of EEC Directive “EMC” 89/336; - requirements of EEC Directive 93/68. [. . . ] • Do not leave acid or alkaline substances, such as vinegar, salt or lemon juice, etc. , on the cooktop. Stainless steel surface • Clean with a specific commercial product. Note: if the cooktop is used continuously, the high temperatures produced by the flames may alter the colour of the surface near the burners. Cleaning the burners 1. Extract the burner from its housing by pulling it up. Soak the burner and the cap in hot water and liquid detergent. Ensure that none of its openings is clogged. Note: to avoid damaging the electric ignition device, do not use it when the burners are not in their housing. Cleaning the electric hotplate The electric hotplate must be cleaned when it is lukewarm. Wipe with a cloth moistened with water and salt, and polish with a cloth moistened with oil. 39 3gb53241b. fm5 Page 40 Friday, April 11, 2003 12:26 PM TROUBLESHOOTING GUIDE 1. The burner fails to ignite: • Is the main gas delivery valve open?• Has the delivery of the town gas (methane) been suspended?• Is the gas cylinder (liquid gas) empty?Fit the brackets into the relevant bores and fasten them by means of their screws. Make an opening in the worktop, respecting the dimensions indicated in the enclosed Product Description Sheet. Important: the power supply cable and plug must be suitable for the power absorption of the cooktop, and the cable must be long enough to permit its upward extraction. 41 3gb53241b. fm5 Page 42 Friday, April 11, 2003 12:26 PM INSTALLATION Electrical connection • The electrical connections must comply with local regulations. • The data relevant to the voltage and power absorption are indicated on the rating plate. • The earthing of this appliance is compulsory by law. • The manufacturer cannot be held responsible for any injury to persons or animals or damage to property arising from failure to comply with these requirements. • When the cooktop is installed, provide a single-pole circuit breaker with a contact separation of at least 3 mm. • If necessary, the electrical power cable must be replaced exclusively with a power cable having identical characteristics to the original supplied by the manufacturer (type H05V2V2-F - T90°C or type HO5RRF). This operation must be performed by the After Sales Service or a qualified electrician. L Earth (Yellow/Green) N Connection to gas supply The gas supply system must comply with local regulations. You can find specific local regulations for some countries, in the separate National Safety Regulations Sheet supplied. If no information concerning your Country is given, please ask details to your Installer. [. . . ] Connect the cooktop to the gas shut-off valve by means of a pipe suitable for the type of gas used, in compliance with current local regulations. Note: when liquid petroleum gas is used (G30/G31), the minimum gas setting screws must be tightened as far as they will go. Replacing the injectors (see table in the enclosed Product Description Sheet) 1. Using a socket spanner of the appropriate size, (C), unscrew the injector to be replaced. Replace it with the injector suitable for the new type of gas. [. . . ]