User manual WHIRLPOOL AKP 366 WH INSTALLATION

[. . . ] • There must be nothing between the cooktop and the oven (e. g. • Any adjacent column unit present must be installed at least 100 mm from the edge of the cooktop (fig. • Cut an opening in the worktop of the dimensions given in the Product Description Sheet supplied with the worktop. • We recommend you seal the internal edges of the worktop with wood glue or silicone. [. . . ] This clearance must never be obstructed (fig. 2). • During installation make sure that the sides of the oven do not touch the adjacent units. • If the kitchen unit is not securely fixed to the wall, it must be anchored with standard brackets (G) commercially available, see fig. 3. 28 10200069aGB. fm Page 29 Monday, January 29, 2007 3:20 PM Electrical connection Regulations require that the appliance be earthed. • Connection to the mains must be carried out by a qualified technician in accordance with the manufacturer's instructions and in compliance with local regulations. • The installer is responsible for connecting appliances correctly to the mains and for observing the safety regulations. • The oven power cable must be long enough to connect the built-in appliance to the mains. • Observance of safety directives requires that a multi-pole switch with a minimum contact gap of 3mm be used for the installation. • Do not use multiple plug adapters or extension leads. • After the oven has been installed, the electrical components must be inaccessible. Power supply cable table N° of conductors 1N+ 2N+ 3 + 3N+ Type of cable H05 RR-F 3 X 4 mm² H05 RR-F 4 X 2. 5 mm² H05 RR-F 4 X 2. 5 mm² H05 RR-F 5 X 1. 5 mm² ~ ~ ~ ~ Connection to the gas supply The gas supply system must be in compliance with local regulations. To connect the cooktop to the gas mains network or gas cylinder, use a rigid copper or steel pipe with fittings complying with local standards, or a continuous-surface stainless steel hose complying with standards. Use gasket “B” when connecting the elbow fitting (fig. Attention: When installing a stainless steel hose, it must not come into contact with any mobile part of the unit. To this end, ensure that the hose is installed where there is sufficient clearance and that it can be inspected along its entire length. Connecting the oven to the power supply • Make sure that the voltage indicated on the rating plate is the same as the mains voltage. The rating plate is on the front edge of the oven (visible when the door is open). Remove the two fastening screws of the terminal box cover located on the bottom part of the oven's rear covering. Remove the cover to gain access to the terminal box and insert the power cable (see table) through the opening located on the bottom of the oven. Connect the cable to the terminal box, tighten the screws as far as they will go and secure it to the cable fastener. Put the cover back on by inserting the two blades in the slots and fasten it with the two screws. Connection and installation Oven - Cooktop with universal joints After installing and fixing the cooktop, install the oven. Connect tabs “A” with terminal part “B” as shown (fig. [. . . ] • Connect the earth wire “C” of the cooktop to the oven “D” as illustrated (fig. • Mount the corresponding knobs in the control panel last. Hob with 4 gas: position of the knobs like in fig. 12. Hob with 3 burners/1 electric hot plate: position of the knobs like in fig. 13. [. . . ]