User manual WHIRLPOOL AKP 632 NB PROGRAM CHART

[. . . ] Carefully observe the following instructions: - The appliance must be disconnected from the power supply before carrying out any installation work. - Installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer’s instructions and local safety regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual. - Power cable replacement must be carried out by a qualified electrician. [. . . ] The oven door can be removed to facilitate cleaning (see MAINTENANCE). • The top heating element of the grill (see MAINTENANCE) can be lowered (some models only) to clean the roof of the oven. N. B. : during prolonged cooking of foods with a high water content (e. g. pizza, vegetables, etc. ) condensation may form on the inside of the door and around the seal. When the oven is cold, dry the inside of the door with a cloth or sponge. Accessories: • • Soak the accessories in water with washing up detergent immediately after use, handling them with oven gloves if still hot. Food residues can be easily removed using a brush or sponge. Cleaning the rear wall and catalytic side panels of the oven (if present): IMPORTANT: do not use corrosive or abrasive detergents, coarse brushes, pot scourers or oven sprays which could damage the catalytic surface and ruin its self-cleaning properties. • Operate the oven empty with the fan-assisted function at 200°C for about one hour • Next, leave the appliance to cool down before removing any food residue with a sponge. Cleaning cycle of ovens with pyrolysis function (if present): WARNING - Do not touch the oven during the pyrolysis cycle. Keep children away from the oven during the pyrolysis cycle. This function burns off spatters produced inside the oven during cooking at a temperature of approx. At this high temperature, the deposits turn into a light ash which can be easily wiped away with a damp cloth, when the oven is cool. Do not select the pyrolysis function after every use, only when the oven is very dirty or produces smoke or fumes while preheating or cooking. • If the oven is installed below a hob, make sure that all burners or electric hotplates are switched off during the self-cleaning (pyrolysis) function. It is advisable to do an automatic cleaning cycle after cooking particularly fatty food (see CLEANING). Turnspit (Fig. 5) Use the turnspit as indicated on Fig. Also check “Recommended use and tips” section for advice. Grill Pan Set (Fig. 6) The set comprises a wire shelf (6a) and an enamelled recipient (6b). This set must be placed on the wire shelf (3) and used with the Grill function. Grease filter (Fig. 7) Use only for particularly greasy cooking. Hook it on the rear wall of the oven compartment, opposite the fan. It can be cleaned in a dishwasher and used with the fanassisted function. Sliding shelves (Fig. 8) They allow the wire shelves and drip-trays to be pulled half out during cooking. Suitable for all the accessories, they can be cleaned in a dishwasher. GB6 CONTROL PANEL DESCRIPTION 4 2 The knobs are retractable. Press the knobs in the middle and they pop up. [. . . ] Use the lowest recommended values to begin with and, if the food is not cooked enough, then move on to higher values. Use the accessories supplied and preferably dark coloured metal cake tins and oven trays. You can also use pans and accessories in pyrex or stoneware, but bear in mind that cooking times will be slightly longer. To obtain best results, follow the advice given in the cooking table for the choice of accessories (supplied) to be placed on the various shelves. [. . . ]