User manual WHIRLPOOL AKP 802 IX INSTRUCTION FOR USE

[. . . ] Between two side panels of two distinct cabinet units without the aid of a support shelf, by fitting four support steel brackets provided with the product. Between two side panels each fixed to the side of a cabinet unit without the aid of a support shelf. In this case only the two lower support brackets will be necessary (fig. Note: In both of the above cases you must measure 717 mm from the underside of the worktop and mark the correct position of the lower support brackets before fixing them to the sides. [. . . ] • This oven is designed solely for use as a home appliance for cooking food. The manufacturer assumes no responsibility for damage caused by improper or incorrect use. • Any repairs or servicing must be carried out exclusively by a qualified technician. • Never expose the oven to atmospheric agents. • Do not put heavy objects on the doors because they could damage the oven cavities and hinges. • Never hang anything heavy on the oven doors handles. • Do not cover the bottom of the oven with aluminium foil or other objects. • The oven doors must close properly. • Do not pour water directly into the inside of a hot oven. • Fruit juice drippings from the baking tray may leave permanent stains. We recommend the oven be cleaned before reusing it. • Never drag pots and pans across the bottom of the oven to prevent the coating from being scratched. • Residual condensation after cooking could damage the oven and surrounding kitchen units in time. We recommend that you: - set the lowest temperature; - cover food; - remove food from the oven; - dry the wet parts when the oven is cool. • The front panel and the handle of the oven doors warm up when the appliance is switched on for a long time at high temperatures. • Never touch the oven with any wet part of the body and do not operate it with bare feet. • Do not pull the appliance or the power supply cable to disconnect them from the electrical supply. • Keep children away from the following elements as they are sources of danger: - the oven and its controls, especially when in operation and immediately afterwards to avoid injury. - packaging (bags, polystyrene, metal parts, etc. ) - an oven to be scrapped. • Make sure that the electrical cables of other appliances used near the oven do not touch hot parts and are not trapped in the oven doors. • Attention: Steam and smoke are vented through an opening located between the control panel and the top oven door. • Do not place inflammable material in the oven or nearby: a fire may break out if the oven is inadvertently switched on. [. . . ] To refit the door, insert the hinges into their seats and open the door fully. Remember to rotate the two movable bolts G used to hook the two hinges before closing the door (fig. WARNING • Take care not to dislodge the hinge lock system when removing the door as the hinge mechanism has a strong spring system!• Do not immerse the door in water at any time. [. . . ]