User manual WHIRLPOOL AKR 027/IX/01 INSTRUCTION FOR USE

[. . . ] • Please make sure that the tabs are correctly positioned as illustrated. • Position the cooktop into the housing. • Put tabs (A) into place; tooth (C) of the tabs should fit into the hole. [. . . ] 2) The blue wire must be connected to the terminal marked N (Neutral), or coloured Black. 3) The brown wire must be connected to the terminal marked L (Live), or coloured Red. DOUBLE POLE SWITCHED FUSED SPUR OUTLET FUSE ON use a 15 amp FUSE 2. For the Republic of Ireland only The information given in respect of Great Britain will frequently apply. Replacing the supply cable • Turn the cooktop upside down and unhook the terminal board cover inserting a screwdriver into the two hooks (A). • Open the strain release (cable clamp) unscrewing screw (F), unscrew the clamps screws and remove the cable. Connect the new supply cable, following the instructions on the separate Product description sheet. 11 3gb66020. fm Page 12 Monday, August 26, 2002 3:32 PM PROTECTING THE ENVIRONMENT 1. Packing The packaging material is entirely recyclable, as confirmed by the recycling symbol . Declaration of conformity These appliances are designed to come into contact with foodstuffs and they are constructed in compliance with Directive 89/109/EEC. • The appliances are designed solely for use as cooking appliances. for room heating) is considered as improper use and potentially dangerous. • The appliances are designed, built and sold in compliance with: • The safety requirements of “Low Voltage” Directive 73/23/EEC. • The protection requirements of EMC Directive 89/336/EEC. • The requirement of Directive 93/68/EEC. • Electrical insulation: Class (I). 2. Products The appliances are built from recyclable materials. If you decide to scrap the appliances act responsibly and observe local waste disposal by laws. [. . . ] • The oil level is higher than the maximum mark. • There is too much food. 12 3gb66020. fm Page 13 Monday, August 26, 2002 3:32 PM AFTER-SALES SERVICE Before contacting After-Sales Service 1. Try to solve the problem (see “Troubleshooting Guide”). [. . . ]