User manual WHIRLPOOL AKR 047/WH INSTRUCTION FOR USE

[. . . ] INSTRUCTIONS FOR USE INSTALLATION ELECTRICAL CONNECTION CONNECTING TO THE GAS SUPPLY REFERENCE TO ITALIAN NATIONAL REGULATIONS BEFORE USING THE OVEN SAFEGUARDING THE ENVIRONMENT PRECAUTIONS AND GENERAL RECOMMENDATIONS OVEN ACCESSORIES COOKING TABLE CLEANING THE OVEN AND ACCESSORIES TROUBLESHOOTING GUIDE AFTER SALES SERVICE DECLARATION OF CONFORMITY CE 26 INSTALLATION Technical information for the installer • It is important that all installation procedures be performed by a qualified technician. • After unpacking the oven to connect it, rest it on its base without damaging it. • Do not attempt to lift the oven by the handle. • Handling the oven must be done by 2 people. [. . . ] • Remove the injector “D” with a 7 mm wrench and replace it in accordance with the instructions given in the separate Product Description Sheet (the injector must be blocked with sufficient force to stop it being drawn off). • Reassemble the burner following the above instructions in reverse order. • Be careful of the spark plug cables and the thermocouple hoses. Adjusting the flame of the oven and grill burners To adjust the flame, proceed as follows: • Loosen screw “C” and rotate ring “D” to position “N” for methane or natural gas and to position “GPL” for cylinder gas, making the movable pointer on the ring line up with the fixed pointer on the burner. This will provide a regular flame. Adjusting the minimum • Open the oven door (the burner only ignites with the door open). • Light the oven and let it burn at the maximum temperature for at least 20-30 minutes. • After ignition, close the oven door. • Turn the thermostat knob back to minimum (min). • Insert a screwdriver into hole B parallel to the thermostat stem and adjust the by-pass to the minimum so that you achieve a low but stable flame. Perform this operation with the oven door closed. • Use a flat-head screwdriver on the by-pass screw. It is sufficient to loosen the screw to adjust the minimum when changing from liquid gas to methane. • For functioning with G30/G31 (LPG) the adjustment screw must be screwed in completely. Important: after adjusting the burner, check that the minimum flame is maintained, testing it by repeatedly opening and closing the oven door. If the flame goes out, adapt the by-pass adjustment. Once the operations (replacing the injector, adjusting the air and minimum) have been completed, turn off the oven and apply the new data plate (showing the type of gas being used) replacing the previous one and renew the seal with sealing wax or an equivalent material. Excess air Regular flame Insufficient air REFERENCE TO ITALIAN NATIONAL REGULATIONS See additional sheet, supplied separately. BEFORE USING THE OVEN • These instructions are only valid for the destination countries whose identification symbols are shown on the cover of the appliance's instruction booklet. • To make the most of your new oven, read the users instructions carefully and keep them on hand for consultation in the future. • Remove the cardboard protection and any protective plastic film. • Remove the accessories from the oven and heat it at the maximum temperature setting for about 30 minutes to eliminate the smell of protective grease and insulating materials. Keep the window open during this operation. 30 SAFEGUARDING THE ENVIRONMENT 1. Packaging • The packaging material can be 100% recycled, as confirmed by the recycling symbol . 2. Electrical appliances • The appliances are built from recyclable or reusable materials. Disposal must be carried out in accordance with local environmental regulations for waste disposal. [. . . ] The hinges “A” are provided with two movable hook-bolts “B” that hook onto sector “C” of the hinges, when they door is completely open, they lock it. • Lift the door upwards and remove towards the outside, grasping the sides of the door close to the hinges. To remount the door: • Insert the hinges into their grooves. • Before closing the door, remove the two movable hook-bolts “B” that were used to hook the two hinges. [. . . ]