User manual WHIRLPOOL AKR 101/IX INSTRUCTION FOR USE

[. . . ] Product This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is correctly scrapped, the user can help prevent potentially harmful consequences for the environment and the health of people. The symbol on the product or the accompanying documentation indicates that this product should not be treated as domestic waste but must be taken to a suitable collection centre for the recycling of electrical and electronic equipment. Disposal must be carried out in compliance with local regulations on waste disposal. [. . . ] The room must have adequate ventilation when the hood is used at the same time as appliances operating on gas or other fuels. The discharge air must not be eliminated in a duct used to remove fumes produced by appliances operating on gas or other fuels, but must have a separate outlet. All the national regulations on air discharge envisaged by art. 7. 12. 1 of CEI EN 60335-2-31 must be observed. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). Therefore, make sure the room is adequately ventilated. Do not leave pans unattended when frying, since the cooking oil could catch fire. Make sure the lamps are cold before touching them. The hood is not a shelf, therefore do not overload or place objects on it. Do not use or leave the hood without its lamps correctly installed - risk of electric shock. Wear work gloves for all installation and maintenance operations. However, a qualified technician is needed to make sure that the plugs are suitable for your ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Disconnect the power supply at the home main switch during electrical connections. 1. Adjust the extension of the hood support structure, as the final height of the hood depends on this. FIG. 1 2. 3. 12. Note: In some cases the top section of the truss is fixed to the bottom section with 1 or more screws. Check for and temporarily remove any screws to enable adjustment of the support structure. Fix the two sections of the structure using 16 screws (4 each corner). For extension beyond the minimum height, fit 1 or 2 brackets (depending on how many are supplied) to the top section to reinforce it. Note: for transport purposes, 1 bracket may be temporarily fixed to the truss already with 2 screws; if so, move it to the desired position and complete the fixing with a further 6 screws. To fit the brackets, proceed as follows: a. Open the brackets slightly in order to fix them to the outside of the structure. [. . . ] THE TABS FOR THE BOTTOM FLUE ARE THE NARROWER AND LESS DEEP ONES). The wider and deeper tabs are those used for the top flue, and must be cut to size. Turn the mains power on again at the central electrical panel and check for correct hood operation. 10 GB F NL E I 5019 318 33249 Halogen lamps: 1. Disconnect the hood from the mains power supply. [. . . ]