User manual WHIRLPOOL AKR 104/AV PROGRAM CHART

[. . . ] Carefully observe the following instructions: • Installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer's instructions and local safety regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual. • The appliance must be disconnected from the power supply before carrying out any installation work. • Earthing of the appliance is compulsory. [. . . ] To prevent damage from occurring, only remove the appliance from its polystyrene foam base at the time of installation. PREPARING FOR INSTALLATION WARNING: very heavy product; hood handling and installation must be carried out by at least two persons. The minimum distance between the support surface of the recipients on the cooking device and the lowest part of the hood must not be less than 45 cm in the case of electric cookers and 65 cm for gas or combination cookers. Furthermore, before installation, check the distances specified in the hob user manual. If the installation instructions for the cooker specify a greater distance between cooker and hood, this distance must be observed. CONNECTION TO THE MAINS POWER SUPPLY Make sure the power voltage specified on the appliance rating plate is the same as the mains voltage. This is located inside the hood, and can be seen if you remove the grease filter. The power cable (H05 VV-F type) must only be replaced by qualified personnel. If supplied with a plug, connect the appliance to a socket complying with current regulations and located in an accessible area. If it does not have a plug (direct connection to the mains power supply) or if the socket is not in an accessible place, fit a suitable double-pole switch that ensures complete disconnection from the power supply in category III overvoltage conditions, complying with the installation rules. GENERAL RECOMMENDATIONS Before use Remove cardboard protection pieces, protective film and adhesive labels from accessories. Make sure the appliance has not been damaged during transportation. Washing in a dishwasher can cause grease filters to turn white, but this in no way affects efficiency. Pull out the handle to remove the filter. Wash the filter and leave it to dry, proceeding in reverse order to refit it. REPLACING THE HALOGEN BULBS IMPORTANT: Replace using 20W max G4 halogen bulbs only. Disconnect the hood from the mains power supply. Use a small screwdriver to gently prise (at the three points indicated) the lamp cover off. Remove the burnt-out lamp and fit a new one. Replace the lamp cover so that it clicks into position. CARBON FILTER (filter hoods only) Retains any unpleasant odours produced during cooking. Fit a new carbon filter every 4 months Fitting or replacing the carbon filter 1. Remove the grease filter (refer to the section "grease filters"). Place the carbon filter on the grease filter. Clamp the carbon filter with the metal catches provided, to be inserted in the holes on the frame. [. . . ] The hood comes supplied with all the materials required for installation on most walls/ceilings. However, a qualified technician is required to ensure that the materials are suitable for your ceiling. INSTALLATION DIMENSIONS Adjacent wall units 800 mm min. centre line 65 cm (gas or combi cookers) 45 cm (electric cookers) Adjacent wall units hob surface GB12 INSTALLATION - ASSEMBLY INSTRUCTIONS The instructions below, to be carried out in the order in which they are numbered, refer to the drawings (using the same numbering) on the last pages of this manual. Mark a vertical centre line on the wall. [. . . ]