User manual WHIRLPOOL AKR 104/IX PROGRAM CHART

[. . . ] 1 cm between the screw head and the wall. Note: Drill all the holes indicated on the template: the top 2 holes are for hanging the hood and the bottom hole is for fixing it securely to the wall. Fit the flue support bracket “G” to the wall and against the ceiling, use the support bracket as hole diagram (the small slot on the support must match the line drawn on the wall - step 1) and mark 2 holes with the pencil, drill the holes (Ø 8 mm), and finally insert 2 plugs. Fix the flue support bracket to the wall with 2 screws. [. . . ] For filter operation, fix the deflector F to the flue support bracket G and connect the other end of the exhaust pipe to the deflector collar F. Make all necessary electrical connections. Fit the flues over the extractor unit, engaging them in their seat above the hood. Slide the top section of the flue and secure it with 2 screws (11a) to the flue support bracket “G” (11b). Refit the carbon filter frame and the grease filter/s and check for correct hood operation. 5019 318 33248 D GB F NL E P I GR 5019 318 33248 Active carbon filter (filter hoods only): The carbon filter must be cleaned once a month in a dishwasher at the highest temperature, using a normal dishwasher detergent. After washing, reactivate the carbon filter by drying it in the oven at 100°C for 10 minutes. Remove the filter holder by turning the knobs 90°. Fit the carbon filter “i” in the filter holder “h”. Reverse the above procedure to re-fit the filter holder and grease filter. 1. Extraction and minimum extraction speed ON/OFF switch. Air outlet (for filter version only) Grease filters: a Metal grease filters have an unlimited life and should be washed once a month either by hand or in a dishwasher at a low temperature and with a short cycle. Do not connect the appliance to the mains power supply until installation has been completed. Always disconnect the hood before cleaning or carrying out maintenance by unplugging it or switching off the power supply. Do not “flambé” food under the hood. Do not leave pans unattended when frying. Regular cleaning and maintenance is essential to correct functioning and good performance. Never use flammable materials as hoses for extracted air. If the hood is used together with other appliances powered by gas or other fuels, ambient negative pressure must not exceed 4 Pa (4 x 10-5 bar). For this reason, make sure the room is adequately ventilated. Exhaust air must not be conveyed through the same flue used by the heating system or other appliances powered by gas or other fuels. The room must be adequately ventilated when the hood is used together with appliances powered by gas or other fuels. Make sure lamps are cold before touching them. [. . . ] Do not use or leave the hood without its lamps correctly installed - risk of electric shock. Note: Always wear work gloves for all installation and maintenance operations. This product has been designed, manufactured and sold in conformity to the following standards: - safety objectives of “Low Voltage” Directive 2006/95/CE (which replaces 73/23/CEE as amended) - protection requirements of the “EMC” Directive 89/336/CEE amended by Directive 93/68/CEE. Troubleshooting guide The hood does not work: • Is the plug properly inserted in the power socket?The hood is not extracting enough: • Is the right speed selected? [. . . ]