User manual WHIRLPOOL AKR 105/WH INSTRUCTION FOR USE

[. . . ] Note: Parts marked with the symbol “(*)” are optional accessories supplied only with some models or parts not supplied, to be purchased separately. Very heavy product; hood handling and installation must be carried out by at least two persons. 5019 318 33304 ? 5019 318 33304 5019 318 33304 SAFEGUARDING THE ENVIRONMENT 1. Packing Packing materials are 100% recyclable and are marked with the recycling symbol . Comply with the local regulations for disposal. The packing materials (plastic bags, polystyrene, etc. ) are a potential source of danger and must be kept out of the reach of children. [. . . ] The appliance is not intended for use by children or persons with limited physical, sensory or mental abilities or without experience and knowledge of it, unless they are under the supervision of or instructed in its use by a person responsible for their safety. To reduce the risk of fire, only use a metal inlet duct. Children must be supervised so that they do not play with the appliance. The product must be disposed of in compliance with local regulations on waste disposal. For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. Regular cleaning and maintenance is essential for correct hood operation and good performance. Frequently clean all encrustations from dirty surfaces to prevent the accumulation of grease. Do not “flambé” food under the hood. The room must have adequate ventilation when the hood is used at the same time as appliances operating on gas or other fuels. The discharge air must not be eliminated in a duct used to remove fumes produced by appliances operating on gas or other fuels, but must have a separate outlet. All the national regulations on air discharge envisaged by art. Failure to comply with these instructions can compromise the safety and quality of the product. AFTER-SALES SERVICE Before using the hood Please read these instructions carefully and keep them for future reference, in order to ensure best use of your hood. The packing materials (plastic bags, polystyrene, etc. ) are a potential source of danger and must be kept out of the reach of children. Make sure the hood has not been damaged during transport. Declaration of conformity This product has been designed, manufactured and put on the market in conformity with: - safety objectives of the “Low Voltage” Directive 2006/95/EC (which replaces 73/23/EEC as amended) - protection requirements of “EMC” Directive 89/336/EEC amended by Directive 93/68/EEC. Troubleshooting guide If the hood does not work: • Is the plug properly inserted in the power socket?If the hood is not extracting enough: • Is the right speed selected?• Do the filters need cleaning or replacing?If the lamp does not work: • Does the lamp need replacing?• Is the lamp correctly fitted? 5019 318 33304 TR GB EXTRACTOR OR FILTERING HOOD INSTALLATION Remove the perimeter extraction panel (if relevant) and the grease filter/s. Pre-assemble the steam deflector on the motor assembly (if relevant): (a. ) fit the steam deflector to the rails of the motor assembly, (b. ) connect up the control panel and the lamps, (c. ) secure with 6 screws 3. 5 x 6. 5. Mark a line on the wall right up to the ceiling, corresponding to the centre-line of the hood. Apply the drilling template to the wall: Align the vertical centre-line on the drilling template with the centre-line drawn on the wall. The template’s bottom edge represents the bottom edge of the hood. [. . . ] Remove the burnt-out lamp and fit a new one. WARNING: Replace using 20W max G4 halogen bulbs only. Close the lighting unit (snap-on). 3 2 3 1. Extraction and minimum extraction speed ON/OFF switch. [. . . ]