User manual WHIRLPOOL AKR 1050 IX PROGRAM CHART

[. . . ] IMPORTANT SAFETY INSTRUCTIONS YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT. This manual and the appliance itself provides important safety messages, to be read and observed at all times. This is the attention symbol, relevant to safety, warning of potential risks to the user and to others. All safety warnings are preceded by the attention symbol and the following words: DANGER: WARNING: Indicates a hazardous situation which, if not avoided, will cause serious injury. [. . . ] GENERAL RECOMMENDATIONS Before use Remove cardboard protection pieces, transparent film and adhesive labels from accessories. Make sure the appliance has not been damaged during transport. During use Do not expose the appliance to atmospheric agents. GB10 ADVICE ON SAFEGUARDING THE ENVIRONMENT Packing disposal The packing materials are 100% recyclable and are marked with the recycling symbol environment, but disposed of in compliance with the local regulations. Product disposal This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring the correct scrapping of this product, the user can help prevent potentially negative consequences for the environment and the health of people. The symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection centre for the recycling of electrical and electronic equipment. The various parts of the packing must not be dispersed in the TROUBLESHOOTING GUIDE The hood does not work Make sure: • There is not a power outage. • A certain speed is actually selected. The hood does not extract sufficiently: Make sure: • The selected speed is sufficient for the amount of fumes and steam present. • The kitchen is adequately ventilated to allow an air inlet. • The air exhaust tube is free of obstructions. The hood stops during operation Make sure: • There is not a power outage. • The differential thermal-magnetic switch (Safety Cutout) has not tripped. The light does not work • Check if the lamp needs replacing. • Make sure the lamp is correctly fitted. The remote control does not work • Check if the batteries need replacing. • Make sure the lithium batteries are correctly fitted. GB11 AFTER-SALES SERVICE Before contacting the After-Sales Service: 1. See if you can eliminate the problem on your own by consulting the "Troubleshooting guide". Switch the hood off and then on again to check if the problem has been eliminated. If the following faults occur, contact the After-Sales Service immediately: • The hood makes strange noises and you are unable to detect any fault in it; • The motor runs unevenly, or strange noises can be heard, or it is faulty; • Switching does not work regularly. If the problem persists after carrying out the above checks, contact the nearest After-Sales Service. Always specify: • A brief description of the fault; • The type of appliance and exact model; • The Service number (the number after the word SERVICE on the dataplate inside the appliance). [. . . ] The diameter of the exhaust pipe must be at least 150 mm. Provide a fixing system suited to the connection flange. This is the front view of your hood when correctly installed 8. Make sure the hose is available and connect it to the hood. [. . . ]