User manual WHIRLPOOL AKR 301/NB/S PROGRAM CHART

[. . . ] If relighting happens too frequently, however, the cooktop recognises that there is something wrong and informs the user. This avoids continuous attempts to relight which could make the product dangerous. • • • • • • • • • • The minute counter can be used when the cooktop is being used, for cooking needs, and when the product is switched off for needs not directly linked to the cooktop. [. . . ] In this case turn the knob to “0”. — If at the end of cooking the cooktop is not switched off by pressing button , after a few minutes pilot light begins to flash and an acoustic signal is given, until the cooktop is switched off. — This obligatory switching off function reduces the consumption of electricity when the product is not working and also makes sure that the product cannot be switched on by accident (knocking the knobs, faults, etc. . . . ) — If the cooktop is used for too long, the display indicates “H” and the cooktop switches off until the electronic components cool down. The indication “H” then flashes. Turn the knob to “0” and light the burners again, if necessary. 3Gb61061. fm5 Page 3 Friday, September 14, 2001 10:52 AM If the burners will not light • The burner will automatically stop within 22 seconds. • One of pilot lights or flashes and an acoustic signal sounds. • Turn the knob back to “0”. • Look for the cause (see “Trouble Shooting Guide” in the separate instruction booklet) and repeat the lighting operations. If the system stops one of the burners: • Turn the burner off and turn the knob back to “0”. • Look for the cause (see “Trouble Shooting Guide” in the separate instruction booklet). To switch off all the burners at the same time in an emergency (e. g. food spills over, etc. ): • Press button . The pilot lights of the lit burners flash. • Remember to put all the knobs back to “0” because if the cooktop is used again and the knobs have not been zeroed, a buzzer will sound. 2) Turn the burner knob to the position required before the pilot lights go out. [. . . ] The burner searches for the minimum and set it automatically. If the knob is positioned on the automatic search and setting of the minimum, the burner lights again until the gas has reached the correct flow rate. • 3Gb61061. fm5 Page 4 Friday, September 14, 2001 10:52 AM DIMENSIONS OF THE COOKTOP AND THE WORKING SURFACE (in mm) NOTE: If the distance “A“ between the wall cabinets is between 660 mm and 680 mm, the height “B” must be a minimum of 520 mm. [. . . ]