User manual WHIRLPOOL AKR 420 WH-1 INSTRUCTION FOR USE

[. . . ] Adjust the distance between the hood and the wall. From inside the hood, mark a hole for the final fixing of the hood. Fit the flue support bracket G to the wall and against the ceiling the small slot on the support must match the line drawn on the wall (step1). Drill 2 holes (Ø 8 mm) and insert 2 wall plugs. [. . . ] Apply the flues and fix them with two 2 screws 2. 9 x 6. 5 (17a) to the flue support G (17b). Slide the bottom section of the flue all the way over the extraction unit until it engages the seat above the hood. 5019 318 33246 D GB F NL E P I GR 5019 318 33246 D GB F NL E P I GR Active carbon filter (filter hoods only): The carbon filter must be cleaned once a month in a dishwasher at the highest temperature, using a normal dishwasher detergent. After washing, reactivate the carbon filter by drying it in the oven at 100°C for 10 minutes. Remove the filter holder by turning the knobs 90°. Fit the carbon filter “i” in the filter holder “h”. Reverse the above procedure to re-fit the filter holder and grease filter. 1. Extraction and minimum extraction speed ON/OFF switch. Grease filters: a Metal grease filters have an unlimited life and should be washed once a month either by hand or in a dishwasher at a low temperature and with a short cycle. Washing in a dishwasher can cause grease filters to turn white, but this in no way affects efficiency. press the handle to remove the filter b. Wash the filter and leave it to dry, proceeding in reverse order to refit it. • Is the lamp correctly fitted? • Children must be supervised so that they do not play with the appliance. Do not connect the appliance to the power supply until installation has been completed. Always disconnect the hood before any cleaning or maintenance, by unplugging it or turning off the main switch in the home. Do not “flambé” food under the hood. Do not leave pans unattended when frying, since the cooking oil could catch fire. Regular cleaning and maintenance is essential for proper hood operation and good performance. Regularly clean all encrustations from dirty surfaces. Regularly clean the filter or replace it if necessary. Do not use flammable materials to duct the extracted air. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4Pa (4 x 10-5 bar). Therefore, make sure the room is adequately ventilated. [. . . ] The discharge air must not be ducted in a flue used for removing fumes produced by appliances operating on gas or other fuels, but must have a separate outlet. All national regulations on air discharge must be observed. The hood is not a shelf, therefore do not overload or place objects on it. Do not use or leave the hood without its lamps correctly fitted otherwise there is risk of electric shock. [. . . ]