User manual WHIRLPOOL AKR 421 WH-1 INSTRUCTION FOR USE

[. . . ] Make sure the hood has not been damaged during transportation. • Installation and connection to the mains and exhaust ducts must be carried out by a qualified technician, in accordance with the manufacturer’s instructions and local safety regulations. SAFEGUARDING THE ENVIRONMENT 1. Packaging The packaging material is entirely recyclable, and marked with the recycling symbol . [. . . ] Grease filter The sponge grease filter should be washed in hot soapy water once a month (soak for 1-2 hours, do not wring. Replace with a new filter every 5-6 washes). • The grease filter paper should be replaced at least once a month. • Grease filter paper with indicator should be replaced at least every two months or whenever the colour becomes visible through the holes of the grille. The paper filter is coloured on one side. This colour should not be visible through the grille holes when the filter is installed. • The metal grease filter has an unlimited life and should be washed once a month by hand or in a dishwasher (60°C) with appropriate detergents. Leave filter to dry before remounting it. Whenever cleaning or replacing the grease filters, clean all other exposed parts of the hood. • Carbon filter (“Air recirculation mode”, see following page) The carbon filter cannot be washed or regenerated. Replace the carbon filter (normal usage) every 6 months (Rectangular carbon filter) every 4 months (Circular carbon filter). Replacing bulbs  Pull out the steam deflector (depending on model).  Open the grille or light fixture and remove the grease filter.  Remove the burnt-out bulb and replace it with a new one of the same wattage. Close the grille, light fixture or metal grease filter. Cleaning the hood Use a soft cloth with methylated spirits or a mild liquid detergent. [. . . ] If the plug is provided, close off the upper exhaust hole. Electrical connection Before connecting the hood, make sure the voltage indicated on the rating plate corresponds to the voltage in your home. The plate is located inside the hood behind the grille. For GB this appliance is supplied without a plug and is intended for direct connection to fixed wiring in accordance with national wiring regulations. [. . . ]