User manual WHIRLPOOL AKR 444 IX INSTRUCTION FOR USE

[. . . ] If not, they must be purchased separately. Note: Parts marked with the symbol ?(*)?are optional accessories supplied only with some models or parts not supplied, to be purchased separately. Very heavy product; hood handling and installation must be carried out by at least two persons. GB INSTALLATION DATA SHEET F FICHE D?INSTALLATION La distance minimum entre la surface de support des rcipients sur le dispositif de cuisson et la partie la plus basse de la hotte ne doit pas tre infrieure 43 cm pour les cuisinires lectriques et 65 cm pour les cuisinires gaz ou mixtes. [. . . ] No conecte el aparato a la corriente elctrica hasta que la instalacin est completamente finalizada. Compruebe si el tubo de descarga y las abrazaderas de fijacin se suministran de serie. En caso contrario, tiene que comprarlos por separado. Advertencia: Las piezas con el smbolo ?(*)?son accesorios opcionales que se suministran slo con algunos modelos, o bien por separado. Producto de peso excesivo; la campana extractora ha de ser transportada e instalada por dos o ms personas. P FICHA DE INSTALAO A distncia mnima entre a superfcie de suporte dos recipientes no dispositivo de cozedura e a parte mais baixa do exaustor do fogo deve ser superior a 43 cm no caso de foges elctricos e de 65 cm no caso de foges a gs ou mistos. Respeite as instrues de instalao do dispositivo de cozedura a gs se estas especificarem uma distncia superior indicada. aconselhvel consultar um tcnico qualificado para a instalao. Para a montagem siga a numerao (1 2 3 . . . . . ). No ligue o aparelho corrente elctrica enquanto a instalao no estiver concluda. Verifique se o tubo de descarga e as braadeiras de fixao foram fornecidos com o aparelho. A qualified technician is needed, however, to make sure that the plugs are suitable for your wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Remove the grease filter/s. 5019 318 33266 D GB F NL E P I GR PRODUCT DESCRIPTION SHEET CONTROL PANEL Light switch. The switch has two positions (lights OFF - lights ON). To switch on the lights: move the switch to the right. The extraction speed switch has 3 settings, depending on the amount of steam and fumes. To increase the extraction speed: move the switch to the right. 1 4 2 3 1. 4. Control panel Grease filter Lighting unit Pull-out steam deflector Maintenance ALWAYS disconnect the hood from the mains before performing maintenance. Grease filter maintenance Once a month wash the grease filter by hand or in a dishwasher at a low temperature and with a short cycle. How to carry out grease filter maintenance: 1. After the grease filter has been cleaned, remount in reverse order, making sure the entire extraction surface is covered. Renewing bulbs: Before doing so, check that the lamps have cooled down. Remove the burnt-out bulb and insert a new one. Close the lighting unit. * Carbon filter maintenance The carbon filter cannot be washed or regenerated and must be changed every 4 months. Fitting or replacing the carbon filter: 1. [. . . ] Packaging materials (plastic bags, polystyrene, etc. ) can be dangerous for children and should be kept well out of their reach. Make sure the hood has not been damaged during transport. Declaration of conformity PRECAUTIONS AND GENERAL RECOMMENDATIONS WARNING! ?Is the plug properly inserted in the power socket?The hood is not extracting efficiently: ? [. . . ]