User manual WHIRLPOOL AKR 474 IXL

[. . . ] All safety warnings specify the potential danger/warning to which they refer and indicate how to reduce the risk of injury, damage and electrical shock resulting from incorrect use of the appliance. Comply with the following instructions: • Installation or maintenance must be carried out by a specialized technician, in compliance with the manufacturer’s instructions and local safety regulations. Do not repair or replace any part of the appliance unless specifically requested in the user manual. € The appliance must be disconnected from the power supply before carrying out any installation work. [. . . ] INSTALLATION After unpacking the appliance, check for any transport damage. In the event of problems, contact the dealer or your nearest After-sales Service. To prevent any damage, only remove the appliance from its polystyrene foam packaging at the time of installation. PREPARING FOR INSTALLATION WARNING: this is a heavy product; the hood should only be lifted and installed by two or more people. The minimum distance between the support of the cooking pans on top of the cooker and the bottom of the hood must not be less than 50 cm for electric cookers and 65 cm for gas or mixed cookers. Before installation also check the minimum distances stated in the manual of the cooker. If the installation instructions for the cooker specify a greater distance between cooker and hood, this distance must be observed. ELECTRICAL CONNECTION Make sure the power voltage specified on the appliance rating plate is the same as the mains voltage. This information may be found on the inside of the hood, under the grease filter. Power cable replacement (type H05 VV-F 3 x 0, 75 mm²) must be carried out by a qualified electrician. If the hood is fitted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place after installation. If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). iXELIUM CLEANING ATTENTION - Do not use steam cleaners. - Disconnect the appliance from the power supply. iMPORTANT: Do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean it immediately with a damp cloth. iMPORTANT: The steel of the hood has iXelium surface treatment. To clean it, proceed as follows: • Use a soft cloth (preferably microfiber) wetted with water or with a normal glass cleaner. € Do not use paper towels, as they may leave marks and bits of paper on the hood. € Do not leave acid or alkaline substances such as vinegar, mustard, salt, sugar or lemon juice on the hood. Use specific detergents to clean the appliance and follow the Manufacturer's instructions. IMPORTANT: Clean the filters at least once a month to remove oil and grease residuals. [. . . ] 5 INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS The hood is designed for installation and use in "Extractor version" or in "Filter version". Note: The model with electric shutter can only be used in "Extractor version" and the exhaust pipe must be connected to a peripheral extraction unit. Extractor Version Fumes are extracted and expelled to the outside through an exhaust pipe (not supplied) fixed to the hood exhaust pipe connector. Depending on the exhaust pipe purchased, provide for suitable fixing to the exhaust pipe connector. [. . . ]