User manual WHIRLPOOL AKR 562 IX INSTRUCTION FOR USE

[. . . ] € Do not pull the power supply cable in order to unplug the appliance. € The electrical components must not be accessible to the user after installation. € Do not touch the appliance with any wet part of the body and do not operate it when barefoot. € The appliance is not intended for use by persons (including children) with any physical, sensory or mental impairment, or without experience and knowledge of the appliance, unless supervised or previously instructed in its use by those responsible for their safety. [. . . ] Do not expose the appliance to atmospheric agents. sAFEGUARDING THE ENVIRONMENT Disposal of packing The packing material is 100% recyclable and is marked with the recycle symbol ( ). The various parts of the packing must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal. Scrapping the product - This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection centre for the recycling of electrical and electronic equipment. - GB10 TROUBLESHOOTING GUIDE The appliance does not work: • Check for the presence of mains electrical power and if the appliance is connected to the electrical supply. € Turn off the appliance and restart it to see if the fault persists. The hood's suction level is not sufficient: • Check the suction speed and adjust as necessary: • Check that the filters are clean: • Check the air vents for any obstructions; The light does not work; • Check the light bulb and replace if necessary; • Check that the light bulb has been correctly fitted; AFTER-SALES SERVICE Before calling the After-Sales Service: 1. See if you can solve the problem yourself with the help of the suggestions given in the "Troubleshooting guide". Switch the appliance off and back on again it to see if the fault persists. If after the above checks the fault still occurs, get in touch with the nearest After-sales Service. Always specify: • a brief description of the fault; • the exact type and model of the appliance; • the service number (number after the word Service on the rating plate), located on the inside of the appliance. The service number is also indicated on the guarantee booklet; • your full address; • your telephone number. If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). cLEANING WARNING - Never use steam cleaning equipment. - Disconnect the appliance from the power supply. iMPORTANT: do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. € Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. iMPORTANT: do not use abrasive sponges or metallic scrapers or scourers. [. . . ] The vertical mid line printed on the drilling template must correspond to the mid line drawn on the wall. The bottom edge of the drilling diagram must correspond to the bottom edge of the hood. Place the support bracket on the drilling template so that it coincides with the dashed triangle. Mark and then drill the two external holes. [. . . ]