User manual WHIRLPOOL AKR 590 NB INSTRUCTION FOR USE

[. . . ] The packing materials (plastic bags, polystyrene, etc. ) are a potential source of danger and must be kept out of the reach of children. Product This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is correctly scrapped, the user can help prevent potentially harmful consequences for the environment and the health of people. The symbol on the product or the accompanying documentation indicates that this product should not be treated as domestic waste but must be taken to a suitable collection centre for the recycling of electrical and electronic equipment. [. . . ] Do not use or leave the hood without its lamps correctly installed - risk of electric shock. Wear work gloves for all installation and maintenance operations. The product is not suitable for outdoor use. The air sucked by the hood must not be eliminated through the same flue of the heating system or other appliances using gas or other fuels. 5019 318 33287 GB F NL E I 5 The mains voltage must match that given on the rating plate located inside the hood. If provided with a plug, connect the hood to a socket complying with the current regulations and located in an accessible area. If it does not have a plug (direct connection to the power supply) or if the plug is not in an accessible place, fit a suitable double-pole switch that ensures complete disconnection from the power supply in category III overvoltage conditions, complying with the installation rules. WARNING: Before reconnecting the hood circuit to the power supply and checking correct operation, always make sure the power cable is correctly fitted and that it was NOT crushed in its housing during installation. Make sure to have this operation carried out by a specialised technician. Electrical connection Cleaning the hood WARNING!Failure to remove oil/grease (at least once a month) could result in fire. Use a soft cloth with a neutral detergent. Never use abrasive substances or alcohol. Before calling the After-Sales Service 1. Check to see if you can fix the problem yourself (see “Troubleshooting Guide”). Switch the appliance off and then on again to check if the problem has been eliminated. If the problem persists, contact the After-Sales Service. Specify: • the type of fault, • the product model given on the dataplate inside the hood, visible on removing the grease filters, • your full address, • your telephone number and area code, • the Service code (the number under the word SERVICE on the dataplate inside the hood, behind the grease filter). If any repairs are necessary, contact an authorised Service Centre (to ensure the use of original spare parts and correct repair). Failure to comply with these instructions can compromise the safety and quality of the product. AFTER-SALES SERVICE Before using the hood Please read these instructions carefully and keep them for future reference, in order to ensure best use of your hood. The packing materials (plastic bags, polystyrene, etc. ) are a potential source of danger and must be kept out of the reach of children. Make sure the hood has not been damaged during transport. Declaration of conformity This product has been designed, manufactured and put on the market in conformity with: - safety objectives of the “Low Voltage” Directive 2006/95/EC (which replaces 73/23/EEC as amended) - protection requirements of “EMC” Directive 89/336/EEC amended by Directive 93/68/EEC. Troubleshooting guide If the hood does not work: • Is the plug properly inserted in the power socket?If the hood is not extracting enough: • Is the right speed selected?• Do the filters need cleaning or replacing?If the lamp does not work: • Does the lamp need replacing? [. . . ] Note: Washing in a dishwasher can b cause grease filters to turn white, but this in no way affects efficiency. press the handle to remove the filter b. Wash the filter and leave it to dry, proceeding in reverse order to refit it. Bulb/s: Remove the filters and remove the burnt-out bulb. [. . . ]