User manual WHIRLPOOL AKR 651 NB PROGRAM CHART

[. . . ] 31833104. fm Page 1 Friday, November 7, 2003 12:13 PM AKR 651 - AKR 956 PL Karta instalacyjna Minimalna odległość od palników: 60 cm (od palników elektrycznych), 75 cm (od palników gazowych, olejowych lub węglowych). Podczas montażu należy przestrzegać kolejności numeracji (1Ö2Ö3Ö. . . . . ). Nie należy podłączać urządzenia do zasilania zanim nie zakończy się całkowicie jego montażu. CS Popis instalace Minimální vzdálenost od sporáků: 60 cm (elektrické sporáky), 75 cm (sporáky na plyn, naftu nebo uhlí). [. . . ] Pentru montaj urmaţi numerotarea (1Ö2Ö3Ö. . . . . ). Nu branșaţi aparatul la curent până când nu terminaţi definitiv operaţia de instalare. GB Installation sheet Minimum height above cooker: 60cm (electric cookers), 75cm (gas, gas oil or coal cookers). To install follow points (1Ö2Ö3Ö. . . . . ). Do not connect the appliance to the electrical power supply until installation is completed.  5019 318 33104 31833104. fm Page 2 Friday, November 7, 2003 12:13 PM AKR 651 - AKR 956 W ! Y Y S T Y R V U T Y 1 R Z 2 5019 318 33104  31833104. fm Page 3 Friday, November 7, 2003 12:13 PM AKR 651 - AKR 956 X V Z 3 P M J F L G D 4  5019 318 33104 31833104. fm Page 19 Friday, November 7, 2003 12:13 PM AKR 651 - AKR 956 Assembly - fig. 1-2-3-4 • • • • • • • • • • In order to facilitate installation of the hood and flue support, trace a centre line on the wall between the hob and ceiling (Z). Position the template against the wall, then mark and drill the holes where indicated (Y). Hang the hood and adjust the position by turning the adjustment screws (S). Remove the grease filters and mark the holes for secure fixing (T-R). Remove the hood and drill the holes (4 x Ø 8 mm). Insert 4 wall plugs and two screws in the top holes: they will ensure secure fixing (X). Fix the flue support (Z) as close as possible to the ceiling with two screws and wall plugs. Check that the support is perfectly aligned with the hood. Fix the hood with two screws at the bottom (D). Installing the exhaust pipe (Extractor version) Warning!The exhaust pipe and clamps are not supplied and must be bought separately. • Connect one end of the exhaust pipe (J) to the hood (G) with the other end directed to the outside. Installing the deflector (Filter version) • • Fix the deflector (F) to the flue support with 4 screws. Connect the deflector to the hood with an exhaust pipe. [. . . ] If the filters are not already fitted, locate one on each side to cover both motor protection grilles, check that pins R on the duct align with slots S, then turn it clockwise until it locks. To remove the carbon filter, proceed in reverse order. Replace the grease filters. R S R S 5019 318 33104 PL CZ SK H RUS BG RO GB  Fig. [. . . ]