User manual WHIRLPOOL AKR 684 NB INSTRUCTION FOR USE

[. . . ] The Manufacturer declines any liability for problems, fires or damage caused to the appliance due to non-compliance with the instructions given in this manual. The hood must be installed by a qualified technician. The installer must respect the installation distances specified on the dataplate of the model/series. F INSTALLATION ET UTILISATION Remarque pour le montage : La distance minimum entre la surface de support des rcipients sur le dispositif de cuisson et la partie la plus basse de la hotte NE DOIT PAS TRE infrieure 50 cm pour les cuisinires lectriques et 65 cm pour les cuisinires gaz ou mixtes. Si les instructions d'installation du dispositif de cuisson gaz indiquent une distance suprieure, il est ncessaire de la respecter. [. . . ] The symbol on the product or the accompanying documentation indicates that this product should not be treated as domestic waste but must be taken to a suitable collection centre for the recycling of electrical and electronic equipment. Disposal must be carried out in compliance with local regulations on waste disposal. For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. WARNING: To reduce the risk of accidents, electric shock, injury or damage, when using the hood comply with the basic precautions, including the following. Always disconnect the hood from the power supply before carrying out any installation or maintenance operation on the appliance. Installation must be carried out by a specialised technician, in compliance with the manufacturer?s instructions and local safety regulations. Earthing of the appliance is compulsory. Never use multisockets and extension leads. The electrical components must no longer be accessible to the user after installation. Do not touch the hood with wet parts of the body or use it when barefoot. Do not pull the appliance power cable to unplug it. do not repair or replace any part of the hood unless specifically indicated in the manual. All other maintenance services must be carried out by a specialised technician. When drilling the wall, make sure not to damage the electrical connections and/or pipes. The ventilation ducts must always discharge to the outside. The Manufacturer declines any liability for improper use or incorrect setting of the controls. IMPORTANT INSTRUCTIONS FOR SAFETY 12. The appliance is not intended for use by children or persons with limited physical, sensory or mental abilities or without experience and knowledge of it, unless they are under the supervision of or instructed in its use by a person responsible for their safety. To reduce the risk of fire, only use a metal inlet duct. Children must be supervised so that they do not play with the appliance. The product must be disposed of in compliance with local regulations on waste disposal. WARNING: Before reconnecting the hood circuit to the power supply and checking correct operation, always make sure the power cable is correctly fitted and that it was NOT crushed in its housing during installation. Make sure to have this operation carried out by a specialised technician. Power cable replacement must be carried out by an authorised Service Centre or a qualified person. Electrical connection AFTER-SALES SERVICE Cleaning the hood WARNING! [. . . ] The self-supporting metal filter has no support grille; to remove it, pull the catches E1 back and remove the filter downwards. The metal filter may eventually become discoloured; this does not affect its filtering capacity. Carbon filter - it can be one of the following types: Shaped V1: Remove the cover W by turning the knobs O 90. Insert the carbon filter inside the special compartment and fix it by turning the knob O 90, then close the cover. [. . . ]