User manual WHIRLPOOL AKR 689 IX INSTRUCTION FOR USE

[. . . ] Distance minimale par rapport à la cuisinière : 65 cm (cuisinière électrique), 75 cm (cuisinière à gaz, mazout ou charbon). Si les instructions d'installation du dispositif de cuisson à gaz indiquent une distance supérieure, il est nécessaire de la respecter. Pour le montage, suivez la numérotation (1Ö2Ö3Ö. . . . . ) et les instructions correspondantes. Ne branchez pas l'appareil tant que l'installation n'est pas terminée. F FICHE D'INSTALLATION NL INSTALLATIEKAART Minimumafstand tot het kooktoestel: 65 cm (elektrische kooktoestellen), 75 cm (kooktoestellen op gas, gasolie of kolen). [. . . ] Als de aanwijzingen voor installatie van het kookapparaat op gas een grotere afstand aangeven, moet hiermee rekening gehouden worden. Volg voor de montage de nummering (1Ö2Ö3Ö. . . . . ) en de bijbehorende aanwijzingen. Geef het apparaat geen stroom totdat de installatie geheel voltooid is.  T01126-J128 5019 318 33059 31833059. fm Page 3 Wednesday, October 30, 2002 3:50 PM AKR 402  T01126-J128 5019 318 33059 31833059. fm Page 4 Wednesday, October 30, 2002 3:50 PM AKR 402 5019 318 33059  T01126-J128 31833059. fm Page 9 Wednesday, October 30, 2002 3:50 PM AKR 402 INSTALLATION - ASSEMBLY INSTRUCTIONS Preliminary information for installing the hood: • • • Disconnect the power supply at the domestic main switch before carrying out electrical connections. In order to facilitate installation, (1) trace a mark on the wall using the alignment axis, position the template so that the central line printed on the template matches the central line marked on the wall. Once it is installed, the bottom part of the template should align with the bottom of the hood (2). Drill four holes (Ø 8 mm) and insert 4 wall plugs (3), then insert 2 screws in the top holes, but do not tighten them completely. Drill two holes (Ø 8 mm) near the ceiling (4) using the flue support as template, check that the centre of flue support is aligned with the central line marked on the wall and insert two wall plugs. Note: fit deflector E on the flue support and connection flange G with two screws each (only for models with filter) (5). Fix the flue support to the wall with two screws and washers (6). Hang the hood (7), remove the grease filters and fix it with two screws and washers (8). An acoustic alarm will indicate that the code has been accepted and memorised. LED F: Indicates carbon filter saturation. This LED is ALIGHT also for extractor operation, press BUTTON 5 until the light goes out. • 5019 318 33059 D GB F NL E P I GR  T01126-J128 31833059. fm Page 11 Wednesday, October 30, 2002 3:50 PM AKR 402 PRODUCT SHEET To clean the grease filter Wash the grease filter at least once a month. Remove the grease filters: pull the spring release handle (A-Fig. After cleaning the grease filter, remount in reverse order ensuring the entire extraction surface is covered. Fig. Fit the carbon filter by fixing it to the hood body with the two specific screws (B-Fig. Use a small screwdriver or any other suitable tool to prize off (C-Fig. Use 20 W max halogen bulbs only, making sure not to touch them with your hands. Close the lighting unit (snap-close). Fig. 3  T01126-J128 5019 318 33059 D GB F NL E P I GR 31833059. fm Page 12 Wednesday, October 30, 2002 3:50 PM AKR 402 PRODUCT SHEET How to use the Remote Control Button 1 =ON / Speed 1 / Speed 2 / Speed 3 / Speed 4 / OFF Button 2 =Timer ON/OFF Button 3 =Light ON/OFF Before using the remote control, set it with the hood: Press and hold buttons 4+5 simultaneously for at least 3 seconds. [. . . ] Close the lighting unit (snap-close). Fig. 3  T01126-J128 5019 318 33059 D GB F NL E P I GR 31833059. fm Page 12 Wednesday, October 30, 2002 3:50 PM AKR 402 PRODUCT SHEET How to use the Remote Control Button 1 =ON / Speed 1 / Speed 2 / Speed 3 / Speed 4 / OFF Button 2 =Timer ON/OFF Button 3 =Light ON/OFF Before using the remote control, set it with the hood: Press and hold buttons 4+5 simultaneously for at least 3 seconds. An acoustic alarm will indicate that the programming is completed. Continuing to hold the buttons mentioned above, press any button on the remote control. [. . . ]