User manual WHIRLPOOL AKR 804 INSTALLATION

[. . . ] D INSTALLATIONSANLEITUNGEN Mindestabstand ber der Kochflche: 50 cm bei Elektroplatten, 70 cm bei Gasmulden oder gemischt betriebenen Kochfeldern. Schreiben die Installationsanweisungen des Gaskochfelds einen greren Abstand vor, ist dieser natrlich zu beachten. Schlieen Sie das Gert erst nach seiner kompletten Installation an das Stromnetz an. Aufgrund des schweren Gewichtes sind mindestens zwei oder noch mehr Personen zur Befrderung und Installation der Abzugshaube erforderlich. GB INSTALLATION DATA SHEET Minimum height above cooker: 50 cm for electric cookers, 70 cm for gas or combined cookers. [. . . ] Fig. 9 Insert the control rod in the special seat. Compulsory coupling direction, with release. Fig. 10 Fix the connection box F to the support bracket on the ceiling with 2 screws. Carry out the electrical connection and secure the cables with the cable clamp G with 2 screws. Fix the connection box cover with 4 screws. Replacement of the interconnection cable must be carried out by the authorised after-sales technical service. Fig. 11 Insert the cover E between the support cables, making sure they enter the special slots on the cover. Leave enough cable so that it passes easily through the slot obtained in the cover. Secure the cover with 3 grub screws already screwed (or to be screwed) on the support bracket B. Note: The 3 fixing screws secure the cover by virtue of the friction they exert on the cover itself, and therefore must not be completely tightened. Fig. 12 Apply the aesthetic tabs I (press-on) to cover the hood fixing rib points 5019 318 33241 D GB F NL E P I GR S N DK FIN LI25BA PRODUCT SHEET Control panel Preliminary information for correct use of the hood: Use the fastest speed setting for particularly concentrated steam and fumes. It is advisable to switch the hood on 5 minutes before starting to cook and leave it running for another 15 minutes at the end of cooking. The hood is equipped with a "TOUCH SENSOR" device able to determine when the control rod is touched by the user, thus enabling control of lights and speeds. For this purpose, carefully read the following instructions. Automatic switching on function The hood is equipped with a temperature sensor that activates the motor at extraction speed (power) 1 when the ambient temperature in the area surrounding the hood exceeds 70C. In any case, the user can still switch off or change the extraction speed (power) (refer to section "Extraction speed (power) control"). Extraction speed (power) control Top part Bottom part Extraction speed (power) selection is cyclic according to the speed sequence stand-by - 1 2 3 4 therefore every time the TOP PART of the control rod is touched the extraction speed (power) increases by one level and switches off (stand-by) if the rod is touched again when the hood is on extraction speed (power) 4. Note: Extraction speed (power) 4 remains on for 5 minutes, after which the extraction motor switches to speed 2. By touching the rod again the extraction motor switches off (Stand-by). Deactivation of carbon filter saturation signalling (for particular applications) Switch off the hood (refer to section "Extraction speed (power) control") Touch the TOP PART of the control rod for more than 5 seconds, the LED will flash GREEN (amber) indicating deactivation of carbon filter saturation signalling. To reactivate carbon filter saturation signalling, repeat the operation, and the LED will flash ORANGE. 5019 318 33241 D GB F NL E P I GR S N DK FIN LI25BA Maintenance ALWAYS disconnect the hood from the mains before performing maintenance. Grease filter It must be cleaned once a month (or when the filter saturation system - if present on model in question - indicates cleaning is necessary) with a mild detergent, by hand or in a dishwasher using a low temperature, short wash cycle. Cleaning in a dishwasher may cause discolouring of the grease filter, but its filtering efficiency is unaffected. [. . . ] Do not "flamb" food under the hood. Do not leave pans unattended when frying, since the cooking oil could catch fire. Regular cleaning and maintenance is essential for correct hood operation and good performance. Regularly clean all deposits from dirty surfaces. [. . . ]