User manual WHIRLPOOL AKR 890 EXTRACTOR OR FILTERING HOOD INSTALLATION

[. . . ] If the product is to be used in EXTRACTOR version, it is necessary to provide an exhaust pipe from the top outlet B to the external outlet vent. In this case a collar (11A) must be fitted on the exhaust outlet B and the carbon filter must be removed. A telescopic flue is also available (as an accessory). Preliminary information for installing the hood: Expansion plugs are provided to secure the hood to most types of ceilings. [. . . ] After-sales service ­ do not repair or replace any part of the hood unless specifically indicated in the manual. All other maintenance services must be carried out by a specialised technician. When drilling the wall, make sure not to damage the electrical connections and/or pipes. The ventilation ducts must always discharge to the outside. The Manufacturer declines any liability for improper use or incorrect setting of the controls. IMPORTANT INSTRUCTIONS FOR SAFETY 12. The appliance is not intended for use by children or persons with limited physical, sensory or mental abilities or without experience and knowledge of it, unless they are under the supervision of or instructed in its use by a person responsible for their safety. To reduce the risk of fire, only use a metal inlet duct. Children must be supervised so that they do not play with the appliance. The product must be disposed of in compliance with local regulations on waste disposal. For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. Regular cleaning and maintenance is essential for correct hood operation and good performance. Frequently clean all encrustations from dirty surfaces to prevent the accumulation of grease. Do not "flambé" food under the hood. The room must have adequate ventilation when the hood is used at the same time as appliances operating on gas or other fuels. The discharge air must not be eliminated in a duct used to remove fumes produced by appliances operating on gas or other fuels, but must have a separate outlet. All the national regulations on air discharge envisaged by art. 7. 12. 1 of CEI EN 60335-2-31 must be observed. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). Therefore, make sure the room is adequately ventilated. Do not leave pans unattended when frying, since the cooking oil could catch fire. Make sure the lamps are cold before touching them. The hood is not a shelf, therefore do not overload or place objects on it. [. . . ] Press or to come out of the function. Fig. 1 1. If the lamps are not working, check that they are fitted properly in place before contacting the After Sales Service. Fig. 3 Fig. 2 Fig. 4 Cleaning the hood Always wait until the hood has cooled down before cleaning it!Failure to remove oil and grease (at least once a month) could lead to fire. Use a soft cloth with a neutral detergent. [. . . ]