User manual WHIRLPOOL AKR 920 NB INSTRUCTION FOR USE

[. . . ] Control panel Light: move the switch to the right or press the next button to switch on. Extraction speed: move the switch to the right or press the next button to increase extraction speed. Grease filter - can be one of the following types: Paper filter: must be replaced once a month or, if the top side is coloured, when the colour shows through the holes in the grille. Metal filter: must be washed once a month by hand or in a dishwasher, using a quick wash cycle with a low temperature. [. . . ] The self-supporting metallic filter has no support grille. To remove it, pull the spring release handlesE1 backwards and remove the filter downwards. Over time, the metallic filtermay become opaque; this in no way affects its filtering capacity. Carbon filter - can be one of the following types: Shaped V1: Remove the cover W by turning the knobs O through 90°. Insert the carbon filter inside the special housing and secure it in place by turning the knob O through 90°, then close the cover. Rectangular V2: insert the rear edge first T and then the front (U) - replace every 6 months. Position the filter in the centre so that it covers the motor-protection grille, make sure that the reference mark X1 or X2 or X3 on the carbon filter is aligned with the the reference mark Y on the fan shroud, then turn clockwise; to remove, turn anti-clockwise, if provided with a tab Z remember to lift it up slightly first. Replacing the bulb/s - Remove the filters then remove the burnt-out bulb (E14 incandescent bulb, 40 W max). G4 halogen bulb, 20 W max: use a small screwdriver or similar suitable tool to prise off. Replace the bulb cover so that it clicks into position. Failure to remove oil and grease at least once a month could lead to fire. The hood is not extracting efficiently: • Is the right extraction speed selected?• Do the filters need to be cleaned or replaced?Light does not work: • Does the bulb need to be replaced?• Is the mains fuse OK? PRECAUTIONS AND GENERAL RECOMMENDATIONS WARNING!• Do not allow children or infirm persons to operate the appliance without supervision. • Make sure that children do not play with the appliance. Do not connect the appliance to the mains electricity supply until installation is completed. Always disconnect the hood from the mains before performing any cleaning or maintenance. Do not flambé food under the hood. Do not leave pans unattended when frying. Regular cleaning and maintenance is essential to correct functioning and good performance. [. . . ] Regular cleaning and maintenance is essential to correct functioning and good performance. Never use flammable materials to convey exhaust air. If the hood is used together with non-electrically powered appliances, ambient negative pressure must not exceed 4Pa (4 x 10 -5 bars). Make sure that the room is adequately ventilated. AFTER-SALES SERVICE Before calling Technical Assistance 1. [. . . ]