User manual WHIRLPOOL AKR 925 IX INSTRUCTION FOR USE

[. . . ] The timer can also be switched off without turning the burner off, as at the end of normal timer use: cooking can then continue for as long as wished without turning the burner off. Residual heat pilot lights at the cooktop centre indicate that the grid is still hot. Attention: When switching on the cooktop after a power failure, the residual heat pilot lights remain off, even if the grids are still hot. Using the search for the minimum the cooktop can automatically identify the lowest minimum compatible with the local gas network distribution conditions at the time the function is used. 5019 319 61061 3Gb61061. fm5 Page 2 Friday, September 14, 2001 10:52 AM • The burner can thus be used for long cooking at the lowest level possible, without turning the knob in the OFF direction, as in traditional cooktops, when the knob minimum is too high. [. . . ] When searching for the minimum the knob checks the flame continuously through its • range, as it has a direct flame-knob link on all its rotation. As in modern cars this cooktop has selfdiagnosis capacity and can signal abnormal situations which require the help of the Technical After-Sales Service. DESCRIPTION OF THE KNOBS AND COOKTOP OPERATION 1. Signal display (Timer/Faults) 12-13-14-15. Residual heat pilot light COOKTOP OPERATION • Switch on the cooktop by pressing button . • Turn the knob corresponding to the burner to be used to the position required. The pilot light near the knob and the residual heat light come on. • As soon as the knob is turned the burner lights completely automatically: a pulsing noise indicates that the safety and gas control systems have been activated and are working correctly. • To turn off the burner turn the knob to “0”. Switch off the cooktop by pressing button . N. B. : If the knobs are not turned before the pilot lights go out, the minute counter function is switched on. 3) When the set time has elapsed, the burner goes out automatically and the timer and knob pilot lights flash. • Turn the knob back to “0”: To stop the timer: a) To zero the time and switch off the burnerturn button or turn the knob to “0”. b) To cancel the timer function press buttons and at the same time. N. B. : the residual heat pilot lights stay on even when the cooktop is OFF, until the burner has cooled down. OPERATION OF THE TIMER/ MINUTE COUNTER (Maximum time: 99 minutes) To use the MINUTE COUNTER: • Select the cooking time required by pressing buttons or . The set time appears on display and the 4 pilot lights and come on for a few seconds. • a few moments after selection, the minute counter starts to count down and a buzzer sounds. • When the set time has elapsed a buzzer sounds. • To zero press buttons and at the same time or zero the time by pressing button . [. . . ] • To zero press buttons and at the same time or zero the time by pressing button . N. B. : The minute counter works even with the cooktop switched off. To use the TIMER: — The timer function can be used for any burner, whether turned off or already lit. 1) Select the cooking time required by pressing buttons or . [. . . ]