User manual WHIRLPOOL AKR 946 WH INSTRUCTION FOR USE

[. . . ] Mark a centre-line on the wall from the cooktop to the ceiling. Bearing in mind the minimum heights over the cooktop specified above, mark the height of the hood on the wall with a pencil and place the template against the wall on the mark. Using the template supplied, mark the holes, drill them and insert the rawlplugs, partly tighten 1 screw in the top rawlplug. Fix the flue support to the wall as close as possible to the ceiling. [. . . ] Fitting or replacing the carbon filter (filter hoods only). 2. Fit the filter/s over the motor: make sure the pins R on the manifold match the slots S, then turn clockwise until locked. Refit the grease filters. 5019 318 33240 D GB F NL E P I GR SAFEGUARDING THE ENVIRONMENT 1. Packing The packing materials are 100% recyclable and are marked with the recycling symbol . Comply with local regulations for disposal. Packaging materials (plastic bags, polystyrene, etc. ) can be dangerous for children and should be kept well out of their reach. Product This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is scrapped suitably, you can help prevent potentially damaging consequences for the environment and health. The symbol on the product or the accompanying documentation indicates that this product should not be treated as domestic waste but must be taken to a suitable collection centre for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For further information on the treatment, recovery and recycling of this appliance, contact your competent local authority, the collection service for household waste or the shop where you purchased the appliance. Electrical connections The mains power supply must correspond to the voltage indicated on the appliance rating plate located inside the hood. If provided with a plug, connect the hood to a power socket complying with current regulations and located in an accessible area. If it does not have a plug (direct connection to the power supply) or if the socket is not in an accessible place, fit a suitable double-pole switch that ensures complete disconnection from the power supply in category III overvoltage conditions, complying with the installation rules. IMPORTANT: Before reconnecting the hood circuit to the power supply and checking correct operation, always make sure the power cable is correctly fitted and that it was NOT crushed in its housing during installation. Cleaning the hood Warning!Failure to remove oil/grease (at least once a month) could result in fire. Use a soft cloth with a neutral detergent. Never use abrasive substances or alcohol. Before using the hood PRECAUTIONS AND GENERAL RECOMMENDATIONS IMPORTANT! The appliance is not intended for use by young children or persons with restricted physical, sensory or mental abilities or without experience and knowledge of the appliance, unless they are under the supervision or instruction of a person responsible for their safety. • Young children should be supervised to ensure that they do not play with the appliance. Do not connect the appliance to the mains power supply until installation has been fully completed. Always disconnect the hood before cleaning or carrying out maintenance by unplugging it or switching off the power supply. Do not “flambé” food under the hood. Do not leave pans unattended when frying. [. . . ] • Is the lamp correctly fitted? AFTER-SALES SERVICE Before calling the After-Sales Service 1. Check to see if you can fix the problem yourself (see “Troubleshooting Guide”). Switch the hood off and then on again to check if the problem has gone. If the problem persists, contact the After-Sales Service. [. . . ]