User manual WHIRLPOOL AKR 951

[. . . ] It is advisable to contact a qualified technician for installation. Do not connect the hood to the electrical power supply until installation is completed. WARNING: Check whether the exhaust pipe and clamps are provided. If not, they must be purchased separately. [. . . ] All the national regulations on air discharge envisaged by art. 7. 12. 1 of CEI EN 60335-2-31 must be observed. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). Therefore, make sure the room is adequately ventilated. Do not leave pans unattended when frying, since the cooking oil could catch fire. Make sure the lamps are cold before touching them. The hood is not a shelf, therefore do not overload or place objects on it. Do not use or leave the hood without its lamps correctly installed - risk of electric shock. Wear work gloves for all installation and maintenance operations. The product is not suitable for outdoor use. The air sucked by the hood must not be eliminated through the same flue of the heating system or other appliances using gas or other fuels. 5019 318 33303 TR GB The mains voltage must match that given on the rating plate located inside the hood. If provided with a plug, connect the hood to a socket complying with the current regulations and located in an accessible area. If it does not have a plug (direct connection to the power supply) or if the plug is not in an accessible place, fit a suitable double-pole switch that ensures complete disconnection from the power supply in category III overvoltage conditions, complying with the installation rules. WARNING: Before reconnecting the hood circuit to the power supply and checking correct operation, always make sure the power cable is correctly fitted and that it was NOT crushed in its housing during installation. Make sure to have this operation carried out by a specialised technician. Electrical connection Cleaning the hood WARNING!Failure to remove oil/grease (at least once a month) could result in fire. Use a soft cloth with a neutral detergent. Never use abrasive substances or alcohol. Before calling the After-Sales Service 1. Check to see if you can fix the problem yourself (see "Troubleshooting Guide"). Switch the appliance off and then on again to check if the problem has been eliminated. If the problem persists, contact the After-Sales Service. Specify: · the type of fault, · the product model given on the dataplate inside the hood, visible on removing the grease filters, · your full address, · your telephone number and area code, · the Service code (the number under the word SERVICE on the dataplate inside the hood, behind the grease filter). [. . . ] Carry out the electrical connection to the mains power supply, only turn on the power supply with assembly completed. Fit the nuts with fixing hooks suppliedinside the top and bottom sections of the flues at the rectangular slots. Join the two top sections of the flue to cover the truss so that one of the slots on the sections is on the same side as the control panel and the other is on the opposite side. Screw the two sections with 8 screws (4 each side - see the plan diagram for joining the two sections). [. . . ]