User manual WHIRLPOOL AKR 969 IX PROGRAM CHART

[. . . ] GB SCHEDA INSTALLAZIONE For installation: The minimum distance between the support surface of the recipients on the cooking device and the lowest part of the hood must not be less than 50 cm in the case of electric cookers and 70 cm for gas or combination cookers. If the installation instructions for the gas cooker specify a greater distance, this must be taken into account. Do not connect the hood to the electrical power supply until installation is completed. WARNING: The exhaust pipe and clamps are not supplied and must be bought separately. [. . . ] Make sure to have this operation carried out by a specialised technician. AFTER-SALES SERVICE Cleaning the hood WARNING!Failure to remove oil/grease (at least once a month) could result in fire. Use a soft cloth with a neutral detergent. Never use abrasive substances or alcohol. Before calling the After-Sales Service 1. Check to see if you can fix the problem yourself (see “Troubleshooting Guide”). Switch the appliance off and then on again to check if the problem has been eliminated. If the problem persists, contact the After-Sales Service. Specify: • the type of fault, • the product model given on the dataplate inside the hood, visible on removing the grease filters, • your full address, • your telephone number and area code, • the Service code (the number under the word SERVICE on the dataplate inside the hood, behind the grease filter). If any repairs are necessary, contact an authorised Service Centre (to ensure the use of original spare parts and correct repair). Failure to comply with these instructions can compromise the safety and quality of the product. Before using the hood Please read these instructions carefully and keep them for future reference, in order to ensure best use of your hood. The packing materials (plastic bags, polystyrene, etc. ) are a potential source of danger and must be kept out of the reach of children. Make sure the hood has not been damaged during transport. Declaration of conformity This product has been designed, manufactured and put on the market in conformity with: - safety objectives of the “Low Voltage” Directive 2006/95/EC (which replaces 73/23/EEC as amended) - protection requirements of “EMC” Directive 89/336/EEC amended by Directive 93/68/EEC. Troubleshooting guide If the hood does not work: • Is the plug properly inserted in the power socket?If the hood is not extracting enough: • Is the right speed selected?• Do the filters need cleaning or replacing?If the lamp does not work: • Does the lamp need replacing?• Is the lamp correctly fitted? 5019 318 33197 PL CZ GB SK H F BG RO NL E SL I HR GB 71 INSTALLATION - ASSEMBLY INSTRUCTIONS Remove the perimeter extraction panel (if relevant) and the grease filter/s. Pre-assemble the steam deflector on the motor assembly (if relevant): (a. ) fit the steam deflector to the rails of the motor assembly (remove the two travel stop screws from the steam deflector if necessary), (b. ) connect up the control panel and the lamps, (c. ) fix in place with the 14 screws (max). Mark a line on the wall right up to the ceiling, corresponding to the centre-line of the hood. Apply the drilling template to the wall: Align the vertical centre-line on the drilling template with the centre-line drawn on the wall. The template's bottom edge represents the bottom edge of the hood. Place the mounting bracket over the drilling template so that it matches the outlined rectangle. Insert two wall plugs in the holes and fix the hood mounting bracket in place with two 5 x 45 mm screws. [. . . ] “Automatic mode” led indicator. Extraction speed 2 led indicator. 5019 318 33197 PL CZ SK H BG RO SL HR GB 73 Maintenance ALWAYS disconnect the hood from the mains before performing maintenance. Wash the grease filter and the carbon filter in a dishwasher once a month, at the highest possible temperature, using normal dishwasher detergent. It is recommended to wash the filters on the their own. [. . . ]