User manual WHIRLPOOL AKR 970 IX PROGRAM CHART

[. . . ] For installation and use: Before installing or using the hood, read this manual carefully. The drawings are at the front of the manual. The Manufacturer declines all liability for any faults, damage or fires caused by the appliance as a result of failure to observe the instructions and recommendations given in this manual. Contact a qualified technician for installation. F MONTAGE ET UTILISATION Remarque pour le montage : La hotte doit tre installe une distance minimum de 50 cm des cuisinires lectriques et de 65 cm des cuisinires gaz ou mixtes. [. . . ] Note: the bracket can be adjusted horizontally, which enables the position of the hood to be adjusted (Fig. Mark a centre-line on the wall from the cooktop to the ceiling (Fig 2. 2). Taking into account the distances from the cooktop, mark the distance from the cooktop with a pencil and place the template against the wall on the mark (Fig 2. 3). Then mark and drill the hole, insert the wall plug and partially tighten 1 screw (Fig. Fix the flue support to the wall as close as possible to the ceiling (Fig 3. 1). For filter hoods, also secure the deflector at this stage (Fig 3. 2). Hang the hood on the partially tightened screw (Fig. 3. 3a - if necessary, adjust the hood horizontally by means of the bracket - Fig- 3. 3b) Mark the hood fixing points: 2 at the bottom: remove the grease filters (Fig. 3. 4), 2 at the top on the sides of the bracket. Remove the hood, drill, insert the wall plugs (Fig 3. 5), refit the hood and firmly tighten all the screws (Fig. 3. 6 - Fig. Extractor Version: fumes are extracted and expelled to the outside through a fumes exhaust hose fixed to the collar at the top of the hood and secured with the special clamp. If the hood is equipped with a carbon filter, this must be removed. The discharge air must not be ducted to a flue used for removing fumes produced by appliances using gas or other fuels, but must have a separate outlet. All national regulations on air discharge must be observed. Filter Hood: Air is filtered through a carbon filter and recycled into the surrounding environment. In this case, fit a fume hose between the collar on the hood and the deflector collar, using clamps. If the hood does not have a carbon filter, order one and fit it before use. Connect the hood to the mains supply and fix the telescopic flue to the flue bracket with two screws. Slide the bottom section down into its seat on the top of the hood (Fig. 4). 5019 318 33208 D GB F NL E P I GR 31833208. fm Page 10 Tuesday, July 18, 2006 10:40 AM 4 1 3 2 Fitting or replacing the carbon filter (filter hoods only). Change the carbon filter every six months. Fit the filters as shown in the figures below. [. . . ] If the problem persists, contact the After-sales Service. the model of hood, stated on the data plate inside the hood, accessible by removing the grease filters. the service code (the number appearing below the word SERVICE on the data plate inside the hood behind the grease filter). If any repairs are needed, contact an authorized Service Centre (to ensure that only original spare parts are used and that repairs are made correctly). [. . . ]