User manual WHIRLPOOL AKR 987/NA INSTRUCTION FOR USE

[. . . ] Carefully observe the following instructions: • Installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer's instructions and local safety regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual. • The appliance must be disconnected from the power supply before carrying out any installation work. • Earthing of the appliance is compulsory. [. . . ] If the hood is fitted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place. If no plug is fitted (direct wiring to the mains), or if the socket is not located in an accessible place, install a standardised double pole power switch that will enable complete isolation from the mains in case of category III overvoltage conditions, in accordance with installation rules. GENERAL RECOMMENDATIONS Before use Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. During use To avoid any damage do not place any weights on the appliance. Do not expose the appliance to atmospheric agents. SAFEGUARDING THE ENVIRONMENT Disposal of packing The packing material is 100% recyclable and is marked with the recycle symbol ( ). The various parts of the packing must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal. Scrapping the product - This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). - By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection centre for the recycling of electrical and electronic equipment. GB9 TROUBLESHOOTING GUIDE The appliance does not work: • Check for the presence of mains electrical power and if the appliance is connected to the electrical supply. • Turn off the appliance and restart it to see if the fault persists. After cleaning, reactivate the carbon filter by drying it in the oven at 100°C for 10 minutes. Change the carbon filter every 3 years or any time it gets damaged. Fitting the carbon filter: 1. Attach the filter at the back to the metal tab on the hood first then at the front to the two knobs. Proceed in reverse order to refit the filter holder and grease filter. GB11 MATERIAL SUPPLIED Remove all the components from the packets. Check that all the components are included. • Hood assembled with motor, LEDs and grease filters installed. • Instructions for assembly and use • Telescopic flues • 1 assembly template • 6 Wall plugs Ø 8mm • 6 Screws Ø 5x45 • 10 screws Ø 3. 5x9. 5 • 4 screws da Ø 4 x 8 • 2 screws Ø 2. 9x6. 5 • 1 screw Ø 3. 5 x 6. 5 • 2 washers • 1 cable clamp • 1 Flue support bracket • 1 baffle • 1 collar • 1 Power cable • 1 command configuration film INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS The hood is designed for installation and use in "Extractor version" or in "Filter version". Note: The model with electric shutter can only be used in "Extractor version" and the exhaust pipe must be connected to a peripheral extraction unit. Extractor Version Fumes are extracted and expelled to the outside through an exhaust pipe (not supplied) fixed to the hood exhaust pipe connector. Depending on the exhaust pipe purchased, provide for suitable fixing to the exhaust pipe connector. IMPORTANT: If already installed, remove the carbon filter/s. [. . . ] Remove the grease filter(s) (one or more filters, depending on the model). Adjust the hood horizontally using a spirit level. Adjust the distance between the hood and the wall using the two screws inside the outer body of the hood. Mark the hole(s) for final fixing of the hood as shown. [. . . ]