User manual WHIRLPOOL AKR471IX

[. . . ] This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others. All safety warnings are preceded by the attention symbol and the following terms: DANGER: WARNING: indicates a hazardous situation which, if not avoided, will cause serious injury. Indicates a hazardous situation which, if not avoided, could cause serious injury. [. . . ] If no plug is fitted (direct wiring to the mains), or if the socket is not located in an accessible place, install a standardized double pole power switch that will enable complete isolation from the mains in case of category III overvoltage conditions, in accordance with wiring rules. GENERAL RECOMMENDATIONS Before use Remove cardboard protection pieces, transparent film and adhesive labels from accessories. Make sure the appliance has not been damaged during transport. During use Do not place weights on the appliance, as they could damage it. Do not expose the appliance to atmospheric agents. SAFEGUARDING THE ENVIRONMENT Disposal of packing The packing material is 100% recyclable and is marked with the recycle symbol full compliance with local authority regulations governing waste disposal. Disposal of the appliance This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is disposed of correctly, you can help prevent potentially damaging consequences for the environment and health. The symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection centre for the recycling of electrical and electronic equipment. The various parts of the packing must be disposed of responsibly and in GB9 TROUBLESHOOTING GUIDE The appliance does not work: • Check the domestic power supply and ensure the appliance is connected to the mains properly. € Switch the hood off and then on again to see if the problem has been resolved. The hood is not extracting satisfactorily: • Check the extraction speed is set to the desired level; • Check the filters are clean; • Check the air vents are not blocked; The light does not work: • Check to see if the lamp needs replacing; • Check to see if the lamp has been fitted properly; AFTER-SALES SERVICE Before calling the After-sales Service: 1. See if you can solve the problem yourself with the help of the “Troubleshooting guide”. Switch the hood off and then on again to see if the problem has been resolved. If, after the above checks, the problem persists, contact your nearest After-sales Service. Always provide: • a brief description of the problem; • the type and specific model of the appliance; • the Service number (this is the number which follows the word SERVICE on the dataplate), inside the appliance. The Service number is also printed on the warranty booklet; • your full address; • your telephone number; If any repairs are needed, contact an authorized Service Centre (to ensure that only original spare parts are used and that repairs are made correctly). cLEANING WARNING: - Do not use steam cleaners. - Disconnect the appliance from the power supply. iMPORTANT: Do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean it immediately with a damp cloth. € Clean the surfaces with a damp cloth. [. . . ] The hood comes supplied with all the materials required for installation on most walls/ceilings. However, a qualified technician is needed to make sure that the plugs are suitable for your ceiling. INSTALLATION DIMENSIONS Adjacent wall units 900 mm min (90 cm wide model) 600 mm min (60 cm wide model) central line Adjacent wall units 65 cm (gas or combi cookers) 50 cm (electric cookers) cooktop surface GB12 INSTALLATION - ASSEMBLY INSTRUCTIONS The instructions below, to be carried out in the order in which they are numbered, refer to the figures (with the same step numbers) given on the last pages of this manual. Note: Some instructions differ depending on the hood body width and height, in which case installation differences are described both in the text and in the figures. [. . . ]