User manual WHIRLPOOL AKS 101 WH INSTALLATION

[. . . ] • The cooktop must be fitted in a worktop with a minimum thickness of 20 mm and a maximum of 50 mm. • There must be nothing between the cooktop and the oven (e. g. • An adjacent column unit must be installed at least 100 mm from the edge of the cooktop (Fig. [. . . ] • If the kitchen unit is not securely fixed to the wall, it must be anchored with standard brackets (G) available on the market, see Fig. 3. Glass-ceramic cooktop Important: Remove any protective film before installing the cooktop. Make sure that that the opening in the worktop for the cooktop is cut according to the dimensions given in the drawing on the Product Description Sheet. Pay attention to the tolerance range. 3 10200157aGB. fm Page 4 Monday, September 5, 2005 3:53 PM The cooktop should not be forced into the worktop. Forcing the glass-ceramic top may cause it to crack (even at a later date)!• If the worktop is made of wood, use the spring clips and screws provided (Fig. 7) as shown, paying attention to the specified distances. • If the worktop is made of marble, plastic, ceramic, stone, etc. , the cooktop must be secured with special brackets (F) (Fig. 7), Code 4819 404 78697 available at After Sales Service. Place the 4 brackets (F) in position in accordance with the thickness of the worktop as shown in Fig. Fasten the 4 screws (G) in the positions (H) (Fig. Put the cover back on by inserting the two blades in the slots and fasten it with the two screws. Power supply cable table N° of conductors 1N+ 2 + 2N+ 3N+ 3 + Type of cable H05 RR-F 3 X 4 mm² H05 RR-F 3 X 4 mm² H05 RR-F 4 X 2. 5 mm² H05 RR-F 5 X 1. 5 mm² H05 RR-F 4 X 2. 5 mm² ~ ~ ~ ~ ~ Interconnecting cooktop and oven Important: do not connect the oven to the power supply before you have finished connecting the oven and cooktop. • Before connecting the oven to the power supply, make sure that the cooktop is among the ones listed in the cooktop/oven pairing product sheet provided. 9) (if present) of the connectors (D) (Fig. 9) located on the top covering of the oven by loosening the fastening screw (M) (Fig. Lift up the cover (L) to gain access to the connectors (D) and connect the connectors of the cooktop (C) (Fig. [. . . ] • Do not use multiple plug adapters or extension leads. • After the oven has been installed, the electrical components must be inaccessible. Connecting the oven to the power supply • Make sure that the voltage indicated on the rating plate is the same as the mains voltage. The rating plate is on the front edge of the oven (visible when the door is open). [. . . ]