User manual WHIRLPOOL AKS 142 IX INSTALLATION

[. . . ] • Do not pour water directly into the inside of a hot oven. • Fruit juice drippings from the baking tray may leave permanent stains. We recommend the oven be cleaned before reusing it. • Never drag pots and pans across the bottom of the oven to prevent the coating from being scratched. [. . . ] • Never pull out fully loaded shelves. Use extreme caution. BEFORE USING THE OVEN • Remove the accessories from the oven and heat it 200°C for about an hour to eliminate the smell of the protective grease and insulating materials. Keep the window open during this operation. • Before using the oven, remove: - stickers on the front and oven door, except for the rating plate; - cardboard protection and protective plastic film from the front panel controls and other parts of the oven; - any sticky labels from the accessories (for example, under the drip tray). 13 6gb55000a. fm Page 14 Wednesday, December 11, 2002 2:39 PM OVEN ACCESSORIES Accessories supplied depend on the model. The accessories provided with the oven are listed in the Product Description Sheet provided separately (under Accessories). Drip tray (1) The drip tray is designed to collect fat and food particles when it is positioned under the grid or as a plate, such as when cooking meat, chicken and fish with or without vegetables. Pour a little water into the drip tray to prevent spatters of fat and smoke. 1 Baking tray (2) For cooking biscuits, cakes and pizzas. 2 Grid (3) The grid can be used to grill food or as a support for baking trays, cake tins and other cooking receptacles. It can be placed on any of the runners in the oven. The grid can be inserted with its curved side facing upwards or downwards. 3 Side catalytic panels (4) The catalytic panels have a special microporous enamel coating that absorbs fat spatters. We recommend an automatic cleaning cycle after cooking particularly fatty food (see “Care and Maintenance”). 4 Turnspit (5) Use the turnspit as indicated in the relevant chapter in the Product Description Sheet supplied separately. 5 6a Kit “Grill Pan Set” (6) The set comprises a grid (6a), an enamel drip tray (6b) and one or two handles (6c). This set must be placed on the grid (3) and used with the Grill function. 6b 6c 6 14 6gb55000a. fm Page 15 Wednesday, December 11, 2002 2:39 PM OVEN ACCESSORIES Grease filter (7) To be used for cooking fatty food only. Hook it onto the rear wall of the cavity in front of the fan. Insert the hinges into their grooves and lower the door fully. Attention: These instructions should be carefully followed both to prevent injury and in order not to damage the oven door and hinges. 1 2 3 To lower the grill heating element (certain models only) Do not attempt to clean the oven until it is cool. • Pull (4) the grill heating element slightly forward and lower it (5). 4 5 16 6gb55000a. fm Page 17 Wednesday, December 11, 2002 2:39 PM Changing the rear oven lamp bulb (if provided): 1. Disconnect the oven from the electrical supply. Let the oven cool before turning the lamp cover left to unscrew it (see fig. Reconnect the oven to the electrical supply. Note: use only 25 W/230 V, E-14 type, T300°C bulbs available from After Sales Service. Important: Do not use the oven until the lamp cover has been repositioned. 1 Changing the side wall lamp (if provided - depends on model): 1. Disconnect the oven from the electrical supply. Let the oven cool before removing the left side runner grid (see fig. Using a screwdriver prise off the lamp cover (see fig. [. . . ] Specify in this case the number that follows the letter “F”. - Check that the mechanical programmer (if provided) is turned to “manual”. AFTER SALES SERVICE Before contacting After Sales Service: 1. Try to solve the problem yourself following the points described in “Troubleshooting Guide”. Turn off the appliance and restart it to see if the fault persists. [. . . ]