User manual WHIRLPOOL AKS 370/NB INSTRUCTION FOR USE

[. . . ] If you are not sure contact the dealer or the nearest service centre. • After removing the oven from its packaging, leave it on the polystyrene base to prevent it from being damaged. • When installing the oven it is advisable to wear protective gloves. • The oven is provided with two side handles (B) to facilitate installation (fig. [. . . ] • Do not use multiple plug adapters or extension leads. • After the oven has been installed, the electrical components must be inaccessible. Connecting the oven to the power supply • Make sure that the voltage indicated on the rating plate is the same as the mains voltage. The rating plate is on the front edge of the oven (visible when the door is open). Remove the two fastening screws of the terminal box cover located on the bottom part of the oven’s rear covering. Remove the cover to gain access to the terminal box and insert the power cable (see table) through the opening located on the bottom of the oven. Connect the cable to the terminal box, tighten the screws as far as they will go and secure it to the cable fastener. Put the cover back on by inserting the two blades in the slots and fasten it with the two screws. Power supply cable table N° of conductors Type of cable 1N+ 2 + 2N+ 3N+ 3 + ~ ~ ~ ~ ~ H05 RR-F 3 X 4 mm² H05 RR-F 3 X 4 mm² H05 RR-F 4 X 2. 5 mm² H05 RR-F 5 X 1. 5 mm² H05 RR-F 4 X 2. 5 mm² 96 Interconnecting hob and oven IMPORTANT: do not connect the oven to the power supply before you have finished connecting the oven and hob. • Before connecting the oven to the power supply, make sure that the hob is among the ones listed in the hob/oven pairing product sheet provided. • Connect the hob connectors (C) (Fig. 10) to the oven connectors (D), making sure that you match the colours and that the connector slots are aligned. • Never use abrasive materials or substances to clean the GLASS, to prevent damaging it. • The unit gets very hot during use. Do not touch the heating elements in the oven. • This oven is designed solely for use as a home appliance for cooking food. The Manufacturer declines all responsibility for inappropriate use or incorrect setting of the controls. • Any repairs or adjustments must be carried out exclusively by a qualified technician. • Never expose the oven to atmospheric agents. 98 • Do not put heavy objects on the door because they could damage the oven cavity and hinges. • Never hang anything heavy on the oven door handle. • Do not cover the bottom of the oven with aluminium foil or other objects. • The oven door must close properly. [. . . ] • Always keep a watch on pans when cooking with oil and grease. Oil and fat can overheat and catch fire!• Never pull out fully loaded shelves. Use extreme caution. BEFORE USING THE OVEN • Remove the accessories from the oven and heat it 200°C for about an hour to eliminate the smell of the protective grease and insulating materials. [. . . ]