User manual WHIRLPOOL AKT 100/NB PROGRAM CHART

[. . . ] The oil and grease might overheat and catch fire!Do not use the hob as a support or worktop. Do not leave the hot plates/cookers turned on when they are empty. Do not rest plastic, aluminium foil, cloths, paper etc. [. . . ] Avoid touching the hob with wet hands or using it when barefoot. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety. Do not allow children to touch: - the hob in general, to avoid burns. During and immediately after use the hob reaches extremely high temperatures; - packing materials (bags, polystyrene, metal parts, etc. ); - the hob to be scrapped. Make sure that the electrical wires of other electrical appliances near the hob do not come into contact with hot parts of the hob itself. DIMENSIONS OF COOKTOP AND WORKTOP (mm) Make sure that the voltage indicated on the rating plate is the same as the mains voltage. Technical data is given on the rating plate on the edge of the hob and also below: CAUTION • TROUBLESHOOTING GUIDE The hob does not work: - Make sure that the power supply is on. - Turn the hob off and on again, to make sure that the problem has been solved. - Make sure that the knob is not turned to “0”. Turn the multi-pole switch to “Off” for a few minutes and then turn it back to “On”. ELECTRICAL CONNECTION Power supply voltage Number of wires x dimensions H05 RR-F 3 x 2, 5 mm H05 RR-F 4 x 1, 5 mm 2 • • • 230 V ~ 230 V 3 ~ + AFTER SALES SERVICE Before you call the After Sales Service • Make sure that you cannot solve the problem yourself following the points described in chapter “Troubleshooting Guide”. If after the above checks the fault still occurs, get in touch with the nearest After Sales Service. Please give: • a short description of the fault; • the exact type and model of hob; • service number (i. e. , the number that follows the word SERVICE on the rating plate under the hob itself). The service number is also indicated on the guarantee booklet; • your full address; • your telephone number. If any repairs are required, please contact an authorised After Sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). Failure to comply with these instructions may compromise the safety and quality of the product. 2 • • • • • Type PFEVS 230 V ~ 50 Hz 6. 2 kW 5019 619 01017 • To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation. INSTALLATION Recommendations Important: Disconnect the hob from the mains before carrying out any installation work or servicing. • All electrical connections must be made before connecting the appliance to the power supply. • Installation must be carried out by a qualified technician in accordance with the manufacturer's instructions and in compliance with local regulations. • Unpack the hob and make sure that the appliance has not been damaged during transport. If you are not sure contact the dealer or the nearest service centre. Electrical connection • • • • • • • • • Regulations require that the appliance be earthed. Connection to the mains must be carried out by a qualified technician in accordance with the manufacturer's instructions and in compliance with local regulations. The installer is responsible for connecting appliances correctly to the mains and for observing the safety regulations. [. . . ] Forcing the glassceramic top may cause it to crack (even at a later date)!• If the worktop is made of wood, use the appropriate brackets, spring clips and screws provided. • Position the 4 clips (A), if not alreay fitted, around the cooktop frame, in the slots provided, see Fig. • Measure the centre of the vertical sides of the cut out a shown in Fig. [. . . ]