User manual WHIRLPOOL AKT 310/IX INSTRUCTION FOR USE

[. . . ] The technical data stated on the rating plate underneath the hob are also provided below: ELECTRICAL CONNECTION Supply voltage 230 ~ + Conductors: number and size HO5 RR-F 3 x 1. 5 mm 2 Avoid touching the hob with parts of the body when wet and never use when barefoot. Avoid children contact with: - the hob in general to avoid physical injury. During and immediately after operation, the hob can reach very high temperatures; - packaging (bags, polystyrene, metal parts etc. ); - the hob to be scrapped. [. . . ] Avoid whenever possible spillage of liquids on the hotplates when still warm. The hob is designed exclusively for domestic use to cook food. The manufacturer declines all liability for inappropriate use or incorrect settings of controls. Avoid exposure of the hob to atmospheric agents. Any repairs or operations must be performed exclusively by an authorised technician. ENAMELLED TOPS • • • • • Type PLATD 230 V~ - 50 Hz 3, 5 kW 5019 319 62090/B To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation. TROUBLESHOOTING GUIDE The hob does not work: - Check for the presence of mains electrical power. - Set the knob to “0” and switch on the hob again to ensure that the fault has been remedied. AFTER-SALES SERVICE Before contacting After-Sales Service: • See if you can solve the problem yourself with the help of the suggestions given in chapter “Troubleshooting Guide”. If after the above checks the fault persists, contact the nearest After-sales Service. Please give: • a brief description of the fault; • the type and exact model of the hob; • the service number (i. e. , the number that follows the word SERVICE on the rating plate, located under the hob). The service number is also indicated on the warranty booklet; • your full address; • your telephone number and area code. If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). Failure to comply with these instructions may compromise the safety and quality of the product. Connection to the electrical mains Note: the yellow/green earthing wire (B) must be connected to the screw. If the power cable is not yet connected: • strip approx. 70 mm of sheath from the power supply cable • strip approx. 10 mm of sheath from the wires • Open the terminal board (C) by pressing the side tabs by means of a suitable tool. • Insert the power cable (D) in clamp (E) and connect the wires to the terminal board. • After the electrical connection, insert the hob from the above and secure on the fixing brackets as shown in figure 1. Declaration of conformity • This cooking hob is suitable for contact with foodstuffs, and complies with EEC Directive 89/109. [. . . ] Make an opening in the worktop, observing the dimensions specified. Fit the seal supplied onto the hob (if not already present), after carefully cleaning the application surface. Fig. 1 • • • • • • • Electrical connection • • • • • • Regulations require that the appliance is earthed. [. . . ]