User manual WHIRLPOOL AKT 360/IX PROGRAM CHART

[. . . ] Do not place plastic, aluminium foil, cloths, paper etc. The hob is fitted with hotplates/cooking zones of different sizes. Use pans whose bottom diameter is equal to, or slightly larger than, that of the hotplates/ cooking zones. PROTECTING THE ENVIRONMENT Disposal of packaging materials • • The packing material can all be fully recycled, as confirmed by the recycling symbol . Do not dispose of the various packaging materials carelessly, but do so responsibly and in full compliance with local authority regulations governing waste disposal. [. . . ] If in doubt, contact the After Sales Service. CARE AND MAINTENANCE WARNINGS • • • • Important: never clean the appliance with high pressure water or steam cleaning equipment. • Clean the hob, when it is cool, after each use. This will prevent the build-up of dirt and make cleaning easier. • Use a clean cloth, absorbent kitchen wipes and washing up liquid or a specific glass ceramic cleaner. • Remove baked-on dirt with the special scraper tool (if provided) and specific cleaning products. • Food spills should be cleaned off before they bake onto the glass ceramic surface. • Do not use abrasive products, chlorine-based cleaners, oven-cleaner spray or pan scourers. • The hob should be treated periodically with specific products available from the shops, following the manufacturer's instructions. TROUBLESHOOTING GUIDE The hob does not work: Type PLCVD 230 V~/50 Hz 2. 9 kW - Check for the presence of mains electrical power. - Switch the hob off and then back on again, to see if the problem has been solved. - Make sure that the knob is not turned to “0”. Turn the multi-pole switch to “Off” for a few minutes and then turn it back to “On”. 5019 319 01502 To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation. AFTER SALES SERVICE Before contacting After-Sales Service: • Make sure that you cannot solve the problem yourself following the points described in chapter “Troubleshooting Guide“. If after the above checks the fault persists, contact the nearest After Sales Service. Please give: • a brief description of the fault; • the type and exact model of the hob; • the service number (i. e. , the number that follows the word SERVICE on the rating plate, located under the hob). The service number is also indicated on the warranty booklet; • your full address; • your telephone number and area code. If any repairs are required, please contact an authorised After Sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). Failure to comply with these instructions may compromise the safety and quality of the product. A fig. 4 INSTALLATION Recommendations Important: Disconnect the hob from the mains before carrying out any installation work or servicing. • All electrical connections must be made before connecting the appliance to the power supply. • Installation must be carried out by a qualified technician in accordance with the manufacturer's instructions and in compliance with local regulations. • Unpack the hob and make sure that the appliance has not been damaged during transport. [. . . ] Insert a separator at least 20 mm from the lower edge of the hob, so that it cannot be accessed by the user. Glass ceramic hob Important: remove any protective film before installing the hob. Make sure that the opening in the worktop for the hob is cut according to the dimensions given in the drawing, paying attention to the tolerance range. Connecting the hob to the power supply Note: the yellow/green earth wire must be connected to the screw marked . If the supply cable is not already connected: • Strip away approximately 70 mm. of the outer sheath of the cable. Assembly 1. [. . . ]