User manual WHIRLPOOL AKT 414/NB INSTRUCTION FOR USE

[. . . ] Do not dispose of the various packaging materials carelessly, but do so responsibly and in full compliance with local authority regulations governing waste disposal. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. [. . . ] These indicator lights switch on as soon as the cooking zones reach a high temperature. These indicator lights remain on even after switching off the relevant cooking zone and they switch off only when the temperature of the cooking zone is no longer dangerous. BEFORE USING THE COOKING HOB Before use, remove: - adhesives stuck on the hob; - cardboard guards and protective plastic film; - check whether the hob has been damaged during transport. If in doubt, contact the After Sales Service. Energy saving • • • • • • • Use pots and pans whose bottom diameter is equal to, or slightly larger than, that of the cooking zones. with little water in order to cut down cooking time. A pressure cooker allows you to save even more energy and time. If the glass ceramic surface should break or crack, refrain from using it and call the After-sales Service immediately. If the hob incorporates halogen cooking elements, do not stare at them. The hob is designed for use as a domestic food cooker only. The Manufacturer declines all responsibility for inappropriate use or incorrect setting of the controls. Do not expose the hob to atmospheric agents. Any repairs or maintenance work on the appliance must be carried out exclusively by a qualified technician. • Unpack the hob and make sure that the appliance has not been damaged during transport. If you are not sure contact the dealer or the nearest service centre. Electrical connection • • Regulations require that the appliance is earthed. Connection to the mains must be carried out by a qualified technician in accordance with the manufacturer's instructions and in compliance with local regulations. The installer is responsible for connecting appliances correctly to the mains and for observing the safety regulations. The power supply cable must be long enough to connect the built-in appliance to the mains. Observance of safety directives requires that a multipole switch with a minimum contact gap of 3 mm be used for the installation. Do not use multiple plug adapters or extension leads. After the appliance has been installed, the electrical components must be inaccessible. • • • • • Preparing the housing unit • • • • • • • • • Cut the worktop to fit before installing the appliance. Carefully remove any shavings or sawdust that could prevent the appliance from running properly. The hob must be fitted in a worktop with a minimum thickness of 30 mm and a maximum of 50 mm. Insert a separator at least 20 mm from the lower edge of the hob, so that it cannot be accessed by the user. [. . . ] If the supply cable is not already connected: • Strip away approximately 70 mm. • Then strip away approximately 10 mm. • Open the terminal board by pushing the side clips in with the help of a tool. • Insert the cable in the cable clamp and connect the wires to the terminal board. [. . . ]