User manual WHIRLPOOL AKT 466/NB/01 PROGRAM CHART

[. . . ] Changing programme selection: If the programme selected is changed during drying, the dryer stops. the “Start (Pause)” indicator lamp flashes. To operate the new programme, again press the “Start (Pause)” button. Interrupting programme: To interrupt a drying cycle, press the “Start (Pause)” button and open the door. [. . . ] The drum rotates at regular intervals to prevent the laundry from creasing. set the programme selector knob to “ ”. Cleaning the lint filter: Open door, pull lint filter up and out of machine and open it. Brush lint using a soft brush or your fingertips. Close lint filter and push firmly back into place. Emptying water container: Pull container out by the handle and empty. Replace the container when empty by pushing it completely back into place. If required, activate child safety lock (additional information can be found in the “Door Reversibility/Child Safety Lock” chapter of the instructions for use). Switching dryer off Please note: Only use additives/plastic items specified as dryer safe and rinse items that have been treated with stain remover thoroughly in plenty of water before drying. Never dry rubber objects or objects stained with vegetable oils in the dryer. 1 Overview of programmes Type of textile Programmes / Drying levels Fabrics Volume of load kg Options Approximate drying times (in minutes) Very wet load Wet load Multi-layered, thick laundry such as: terry towels, dish cloths and dry towels, bed linen, underwear, terry towelling bath robes. • Is the heat exchanger dirty?(for more information, refer to the instructions for use) • Is the room temperature too high? • Are the “ ” and “ ” indicator lamps lighting up?The drying cycle is complete and the laundry can be taken out. €¢ If the drying result does not meet your expectation, select a more dry programme. €¢ Is the plug properly inserted into the mains electricity socket?€¢ Is there a power failure?€¢ Has any fluff on the heat exchanger seal been wiped away?€¢ Has any fluff on the door seal been wiped away? • Has the water container been inserted correctly?AFTER-SALES SERVICE If the fault is still present once the above checks have been undertaken or should the fault occur for a second time, switch the machine off. [. . . ] The indicator lamp flashes during the selection phase and lights up during drying. Overdry protection Drying Anticrease End of cycle Indicator lamps Filter The indicator lamp lights up when the filter and/or heat exchanger need cleaning. Clean the filter at the end of every cycle. options Gentle Reduces drying intensity (recommended for delicate items). [. . . ]