User manual WHIRLPOOL AKT 653/WH PROGRAM CHART

[. . . ] Keep the packaging material (plastic bags, polystyrene parts, etc. ) out of the reach of children, as they are potentially dangerous. Check whether the hob has been damaged during transport and remove any protective film from the appliance parts. This hob (Class 3) is designed solely for household use for cooking food. Any other use (such as heating rooms) is to be considered improper and, as a consequence, dangerous. [. . . ] After removing the grids, please ensure that all the feet are correctly fitted. • Attention: the glass lid (if provided) may shatter if overheated. Before closing it, make sure that all the burners are off. After use, make sure that the knobs are in position OFF and close the main gas delivery or cylinder tap REFERENCE TO LOCAL REGULATIONS CZ SK Ensure that the installation and gas connections are performed by a qualified technician, following the manufacturer's instructions and in compliance with current local safety regulations. INSTALLATION TECHNICAL INFORMATION FOR THE INSTALLER • • This product can be embedded in a worktop 20 to 40 mm thick. If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening in the work surface. This panel must be positioned at a maximum distance of 150 mm below the upper surface of the work surface but, in no case less than 20 mm from the bottom of the hob. If there is an oven beneath the hob, make sure that it is manufactured by Whirlpool and equipped with a cooling system. The manufacturer declines all liability if another brand oven is installed beneath the hob. Before installation, make sure that: the local gas delivery conditions (nature and pressure) are compatible with the settings of the hob (see the rating plate and injector table). the outer surfaces of the furniture or appliances adjacent to the hob are heat resistant according to local regulations. combustion products are discharged outdoors through specific hoods or wall and/or window mounted electrical fans. Use pressure regulators suitable for the gas pressure indicated in the Product Description Sheet. L Earth (yellow/green) N ELECTRICAL CONNECTION • • • The electrical connections must comply with local regulations. The data relevant to the voltage and power absorption are indicated on the rating plate. The earthing of this appliance is compulsory by law. • • • The gas nozzles must be changed by After Sales Service or a qualified technician. Nozzles not supplied with the appliance must be ordered from After Sales Service. Adjust the minimum setting of the taps. Note: when liquid petroleum gas is used (G30/G31), the minimum gas setting screw must be tightened as far as it will go. Should you experience difficulty in turning the burners knobs, please contact the After Sales Service for the replacement of the burner tap if found to be faulty. • • • The manufacturer cannot be held responsible for any injury to persons or animals or damage to property arising from failure to comply with these requirements. When the hob is installed, provide a single-pole circuit breaker with a contact separation of at least 3 mm. If necessary, the electrical power cable must be replaced exclusively with a power cable having identical characteristics to the original supplied by the manufacturer (type H05V2V2-F T90°C or H05RR-F). This operation must be performed by a qualified electrician. REPLACING THE INJECTORS (see the injector table in the Product Description Sheet) • • • • Remove grids (A) Extract burners (B) Using a socket spanner of the appropriate size unscrew the injector (C) Replace it with the injector suitable for the new type of gas. Assembly 1. Position the clips (A) in the spaces provided on the hob trim (fig. Measure the centre point of the vertical sides of the cut-out (fig. [. . . ] All the burner parts have been positioned correctly. The burner does not stay lit Check that: When lighting the burner, the knob has been pressed for enough time to activate the protection device. The burner openings are not clogged near the thermocouple. The end of the thermocouple is not dirty. [. . . ]