User manual WHIRLPOOL AKT 657/IX INSTRUCTION FOR USE

[. . . ] Packaging • • • • • • • These instructions are only valid for those Countries where the destination abbreviations are mentioned on the product description sheet and on the hob. Keep the packaging material (plastic bags, polystyrene parts, etc. ) out of the reach of children, as they are potentially dangerous. Check whether the hob has been damaged during transport and remove any protective film from the appliance parts. This hob (Class 3) is designed solely for household use for cooking food. [. . . ] If there are other fuel burning appliances in the same room B. S. 5440 - Part 2 should be consulted to determine the air vent requirements. If the appliance is installed in a cellar or basement, it is advisable to provide an air vent of 65 cm, irrespective of the room volume. • • • NOTES: Gas Safety Regulations The law requires that all gas appliances are installed by competent persons in accordance with the current gas safety regulations. Failure to install appliances correctly may lead to prosecution. It is in your own interest, and that of safety, to ensure that the law is complied with. The hob should be installed in accordance with the Gas Safety (Installation and Use) Regulations, the Building Regulations issued by the Department of the Environment and the Building Standard (Scotland) (Consolidation) Regulations, issued by the Scottish Development Department. In the G. B. , CORGI registered installers work to safe standards of practice. IT Regulation for room ventilation Note: If the appliance is not equipped with safety devices on the burners (thermocouples), the air vents must be increased by 100%, and must be at least 200 cm2), in compliance with M. D. 21 April 1993. Improper use of the grids could scratch the hob. Do not position the grids upside down or drag them across the hob. If the hob has a glass ceramic top, do not use: - Cast iron griddles or terracotta pots and pans - Heat diffusers (e. g. Before connecting the tube to the elbow fitting (A), interpose the washer (B) supplied, in compliance with EN 549. A fig. 4 • For setting into a marble worktop, contact the After-sales Service for the installation kit and necessary instructions. 4812 310 19277 Installation kit for marble worktop. Attention: if a stainless steel hose is used, it must be installed so as not to touch any mobile part of the furniture. It must pass through an area where there are no obstructions and where it is possible to inspect it on all its length. • After connection to the gas supply, check for leaks with soapy water. ADJUSTMENT TO DIFFERENT TYPES OF GAS If the appliance is intended to operate with a different gas from the gas type stated on the rating plate and orange sticker applied on the top of the hob, change the injectors. Remove the orange sticker and keep it with the instructions booklet. Use pressure regulators suitable for the gas pressure indicated in the Product Description Sheet. L Earth (yellow/green) N ELECTRICAL CONNECTION • • • The electrical connections must comply with local regulations. The data relevant to the voltage and power absorption are indicated on the rating plate. The earthing of this appliance is compulsory by law. • • • The gas nozzles must be changed by After Sales Service or a qualified technician. Nozzles not supplied with the appliance must be ordered from After Sales Service. [. . . ] • At this stage, light up the burners and turn the knobs from max position to minimum position to check flame stability. Upon completion of adjustment, reseal using sealing wax or an equivalent material. TROUBLESHOOTING GUIDE The hob may not work or work incorrectly. If any repairs are required, please contact an authorised After-Sales Service, as indicated in the warranty. Note: Failure to comply with these instructions may compromise the safety and quality of the product. • • • • CLEANING THE HOB PARTS • • • • • Grids, burner caps and burners can be removed to be cleaned. [. . . ]