User manual WHIRLPOOL AKT 773 IX PROGRAM CHART

[. . . ] accompanying the product, indicates that this appliance may • Do not allow children or infirm persons to operate the not be treated as household waste. Instead it shall be barbecue without supervision. handed over to the applicable collection point for the • Make sure children do not play with the appliance. recycling of electrical and electronic equipment. [. . . ] for a few minutes to allow fat to be absorbed and burnt USING THE BARBECUE FOR THE FIRST TIME by the lava stone. • Remove the adhesive film which protects some parts. TABLE FOR GRILLING • Carefully remove all the glue residues without using Times given are indicative and refer to the barbecue preheated to abrasive substances, to avoid scratching the surfaces. • Wash and dry the grill carefully (better if in the dishwasher). TABLE OF COOKING TIMES • Raise the heating element (A) until touching the stop Energy regulator Time Foods (B) Fig. Insert the tray and correctly position it, then position (min. ) evenly distribute the lava rock. Lower the heating Beef fillet 12 8 element and put the grill on top. Steaks 12 12 • Lower the heating element and put the grill on top. 12 14 • Switch the barbecue on by turning the energy regulator Hamburgers Sausages 12 13 knob to the maximum position (11-12) for about 15 Liver 12 5 minutes to remove the fatty residues. Lamb chop 12 8 USING THE BARBECUE 12 9 • Before cooking, check that the removable parts are in their Chicken steak Chicken thigh 11 - 10 17 correct position (tray with well distributed lava stone, heating element completely lowered, grill in position). Salmon steak 11 - 10 10 • Switch on the barbecue by turning the knob to position 12. Trout 11 - 10 12 • The indicator light shows that the barbecue is On. If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). Failure to comply with these instructions may compromise the safety and quality of the product. Note: the yellow/green earthing wire (B) must be connected to • This cooktop is suitable for contact with foodstuffs and the screw. If the power cable is not yet connected: complies with EEC (CE) Regulation n. 70 mm of sheath from the power supply • This cooking hob has been designed to be used only for cable cooking Any other use (such as heating a room) is • strip approx. 10 mm of sheath from the wires improper and dangerous • open the terminal board (C) by pressing the side tabs • This cooking hob has been designed, constructed and by means of a suitable tool. marketed in compliance with: • insert the power cable (D) in clamp (E) and connect - safety objectives of the “Low Voltage” Directive 2006/ the wires to the terminal board. 95/CE (which replaces 73/23/CEE and subsequent • close the terminal board cover. • after the electrical connection, insert the hob from the - protection requirements of EEC Directive “EMC” above and secure on the fixing brackets as shown in figure 1. 89/336; - requirements of EEC Directive 93/68. TROUBLESHOOTING GUIDE The heating element does not work: Check whether : - The ON indicator light is off. In this case disconnect immediately the power cable and call the After-Sales Service. INSTALLATION Recommendations Important: Before any installation or maintenance operation, disconnect the barbecue from the mains power supply. • Electrical connections must be made before connecting the appliance to the electricity supply. [. . . ] 1 Preparation of fitted cabinet • Perform all required cuts on the work top before inserting the appliance. Carefully remove all chips or residue which could impair efficient operation of the appliance. • The barbecue must be recessed in a work top with a thickness of min. • Insert a separator panel at a minimum distance of 20 mm from the bottom of the barbecue, so that it is not accessible to the user. [. . . ]