User manual WHIRLPOOL AKT 793/IX PROGRAM CHART

[. . . ] This burner safety device shuts off the gas supply to the burner if the flame goes out accidentally (because of sudden draught, an interruption in the gas delivery, boiling over of liquids, etc. ). • - The device must not be pressed for more than 15 sec. If, after that time has elapsed, the burner does not remain lit, wait at least one minute before trying to light it again. The burner might go out when the knob is released. This means that the thermocouple has not warmed up enough. [. . . ] NOTES: • Ensure that the installation and gas/electrical connections are performed by a qualified technician in • Improper use of the grids can result in damage to the hob surface. Do not position the grids upside down or drag them compliance with current local safety regulations. • This appliance should only be installed and used in well-ventilated rooms, in accordance with current • If the hob has a glass ceramic top, do not use: regulations. Carefully read the instructions before installing and using this appliance. - Cast iron griddles or terracotta pots and pans • Gas adjustment and supply pressure are indicated on the rating plate located under the hob. metallic mesh) appliance is arranged for a type of gas different from that available, refer to the paragraph “Ajustment to - Two cookers for the same pot different types of gas”. • In case of prolonged use, additional ventilation may be needed (opening a window or increasing the extraction force of REFERENCE TO LOCAL REGULATIONS the hood). • Keep children away from the hob when it is in use and do not let them play with the controls or any other appliance IT parts. Warning : the protective rubber feet on the grids represent a chocking hazard for young children. After removing the Regulation for room ventilation grids, please ensure that all the feet are correctly fitted. Note: If the appliance is not equipped with safety devices on the burners (thermocouples), the air vents must be increased by 100%, and must be at least 200 cm2), in compliance with M. D. • Attention : the glass lid (if provided) may shatter if overheated. Before closing it, make sure that all the burners are off. After use, make sure that the knobs are in position OFF and close the main gas delivery or cylinder tap Connection to gas supply Before connecting the appliance, make sure that the gas supply system complies with standards UNI-CIG 7129 and INSTALLATION UNI CIG 7131. Gas connection TECHNICAL INFORMATION FOR THE INSTALLER • This product can be embedded in a worktop 20 to 40 mm thick. • If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening in the work surface. This panel must be positioned at a maximum distance of 150 mm below the upper surface of the work surface but, in no case less than 20 mm from the bottom of the hob. In the case that you intend to install an oven beneath the hob, make sure that it is manufactured by Whirlpool and equipped PROTECTING THE ENVIRONMENT with a cooling system. The manufacturer declines all liability if another brand oven is installed beneath the hob. [. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. b) made in such a way that it cannot be obstructed from the inside or outside (not even accidentally); Disposal must be carried out in accordance with local environmental regulations for waste disposal. c) protected by plastic grids, metallic mesh, etc. , taking care not to reduce the air vent effective area mentioned above; For more detailed information about treatment, recovery and recycling of this product, please contact your local city d) located near floor level and positioned so as not to interfere with the operation of the exhaust system. [. . . ]