User manual WHIRLPOOL AKT 802/NE INSTALLATION

[. . . ] 1 • Measure the centre of the vertical sides of the cut out a shown in Fig. • Position the centre of the brackets (C) on the centre of the side previously identified. • The upper edge of the brackets must be flush with the worktop surface. • Secure using the 4 screws (B) provided that should screwed into the pre-prepared holes. [. . . ] By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health. The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local authority, the household waste disposal service or the shop where you purchased the product. Declaration of conformity CE • This cooktop is suitable for contact with foodstuffs and complies with EEC (CE) Regulation n. • The appliances are designed solely for use as cooking appliances. for room heating) is considered as improper use and potentially dangerous. • The appliances are designed, built and sold in compliance with: • safety objectives of the “Low Voltage” Directive 2006/95/EC (which replaces 73/23/EEC and subsequent amendments); • the protection requirements of Directive “EMC” 2004/108/EC; • the requirements of Directive 93/68/EEC. 15 PRECAUTIONS AND GENERAL RECOMMENDATIONS WARNING: Accessible parts become very hot when the equipment is in operation. Keep children away from the appliance in order to avoid the risk of scalding and burns. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety. Make sure children do not play with the appliance. • Before any maintenance on the appliance, disconnect it from the electrical power supply. • Keep children away form the appliance when it is in use and also when it has been just switched off. • The appliances must be repaired or adjusted exclusively by a qualified technician. • Make sure that the electrical wires of other electrical appliances near the hob do not come into contact with hot parts. • Do not switch on the hotplates/cooking zones when there is no pan in position. • Avoid the use of high pressure water or steam cleaning equipment. • If liquid spills or boils over, the hob may switch off: to enable it to be switched back on again, carefully dry the controls zone. • The cooktop features different size hotplates/ cooking zones. Use pots whose base diameter is the same as that of the hotplate/cooking zone. To avoid permanently damaging the glass ceramic cooktop, do not use: - pots with bottoms that are not perfectly flat; - Metal pots with enamelled bottom. • Do not use the cooktop as a work surface or a support surface. [. . . ] Wait a few minutes until the hob cools down. • • 1. 2. AFTER SALES SERVICE Before contacting After Sales Service 1. Try to solve the problem (see “Troubleshooting Guide”). Turn off the appliance and restart it to see if the fault is repeated. If after the above checks the fault still occurs, get in touch with the nearest After Sales Service. [. . . ]