User manual WHIRLPOOL AKZ 122/NB/01 INSTALLATION

[. . . ] 10200149aGB. fm Page 2 Monday, September 5, 2005 2:24 PM INSTALLING THE BUILT-IN / UNDER THE COUNTER COLUMN OVEN Recommendations Important: Disconnect the oven from the mains before carrying out any installation work or servicing. • Installation must be carried out by a qualified technician in accordance with the manufacturer's instructions and in compliance with local regulations. [. . . ] The rating plate is on the front edge of the oven (visible when the door is open). • If the oven does not have a power supply cable proceed as follows: 1. Remove the two fastening screws of the terminal box cover located on the bottom part of the oven's rear covering. Remove the cover to gain access to the terminal box and insert the power cable (see table) through the opening located on the bottom of the oven. Connect the cable to the terminal box, tighten the screws as far as they will go and secure it to the cable fastener. Put the cover back on by inserting the two blades in the slots and fasten it with the two screws. Power supply cable table N° of conductors Type of cable 1N+ 2+ Preparing the housing unit • Kitchen units in contact with the oven must be heat resistant (80 °C min). • Cut the kitchen unit to fit before installing the appliance. Carefully remove any shavings or sawdust that could prevent the appliance from running properly. • The dimensions of the oven and unit are shown in figures 1-2-3. [. . . ] • Make sure that the plastic spacers (if provided) are positioned correctly in the fastening holes. Then anchor the oven to the housing unit with the screws provided. Electrical connection Regulations require that the appliance be earthed. 2 Fig. [. . . ]